Loading ...
Loading ...
Loading ...
English
10
Replacing the Cutting Line (Fig.A,O–R)
WARNING: To reduce the risk of serious
personal injury, turn unit off and remove the battery
pack. An accidental start-up can causeinjury.
CAUTION: To avoid appliance damage, if
the cutting line protrudes beyond the trimming blade,
cut it off so that it just reaches theblade.
1. Removebattery.
2. Turn spool
22
clockwise to unlock as shown in Fig. O.
The white nub
23
(Fig. R) inside the spool will rotate
away from the spool window
24
(Fig. O) to indicate it
isunlocked.
Fig. O
24
22
3. Pull the spool straight out toremove.
4. Remove any dirt and grass from the spool andhousing.
5. First, wind new line in the channel of the spool closest
to the holding slots
25
as shown in Fig.P.
6. Place the end of the cutting line
26
into the retaining
hole
27
.
Fig. P
27
26
25
7. Wind the cutting line onto the spool in the direction of the
arrow on the bottom of the spool. Make sure to wind the
line on neatly and in layers. Do notcrisscross.
8. When the wound cutting line reaches the beginning
of the holding slots
25
, cut the line approximately 4"
(106mm).
9. Push the line in the holding slots on one side of the spool
to hold the first line while you wind the secondline.
10. Repeat the above procedure for the second cutting line
on the lower section of thespool.
CAUTION: Before you begin trimming, only
use the appropriate type of cutting line. Ensure that
cutting line is present in both sections of the spool as
shown in Fig.Q.
Fig. Q
11. Once both lines are wrapped around the spool
22
,
place your thumb and finger on the holding slots to
further secure the string and feed the end of each line
through the two holes
28
on either side of the head in
the spool housing
9
as shown in Fig.R.
12. Line up the white nubs
23
inside the spool housing
with the recesses
29
of the spool. Align the holding
slots
25
with the two holes
28
as close aspossible.
13. Push the spool into the spool housing and turn
counterclockwise to lock the spool in place. Ensure the
white nub
23
appears in the spool window
24
. Make
sure the line doesn't unravel and wrap around the shaft
below thespool.
14. Pull both ends of the cutting line to release them from the
holding slots. If the line extends past the cutting blade on
the guard cut the line so it just reaches theblade.
Fig. R
28
23
29
Replacing Spool Housing (Fig.A,S, T)
1. Rotate the spool housing
9
until the hole
30
in the
spindle lines up with notch
32
in the guard
8
. A third
hole
33
in the motor housing
4
will be visible as
shown in Fig.S. Insert screwdriver through each all three
holes to prevent the spool housing fromturning.
2. Turn the spool housing clockwise as shown in Fig.T.
3. Insert a screwdriver back through the three holes
(
30
,
32
, and
33
) and thread the new spool housing
counterclockwise and securely tighten onto the bolt
34
protruding from thetrimmer.
Fig. S
4
33
30
32
Loading ...
Loading ...
Loading ...