Loading ...
Loading ...
Loading ...
15
minutes, and relight grill per instructions on page 10 under
section titled: LIGHTING YOUR GRILL.
Two models are available with the timer in the LEGACY series:
S27T and S36T available in Natural Gas or Propane Fuels. To
operate a grill with a built-in timer, follow the instructions below:
1. Open grill hood and turn all control knobs to
the “OFF” position.
2. Turn Black Knob on Green Gas Flow Timer
CLOCKWISE past the desired time and then
back to the desired cooking time position.
3. Turn any control knob to the “HIGH” setting
and depress ignitor button to light desired
burner.
4. If grill fails to light within five seconds, turn
control valve (s) to the off position and allow
gas to clear for 5 minutes, follow above
procedure again.
5. If grill still fails to light, see MANUAL LIGHTING
section on page 10.
6. If grill still fails to light, see TROUBLE
SHOOTING SECTION found on page 12.
7. When done grilling, turn all control knobs to the
“OFF” position and allow timer to run out.
8. NEVER TURN KNOB GAS FLOW CONTROL
KNOB COUNTER CLOCKWISE.
The S27T and S36T come equipped with control knobs
with set screws that are theft resistant with the use of an
Allen screw to secure.
Shown: S36T on S36 Cart
TIMER TROUBLESHOOTING
PGS uses the finest mechanical timer available to control the gas
flow to grill head. Operating instructions are found on the
following page and if followed should provide safe and long
lasting use of timer.
The timer knob should turn freely, if it impinges on the control
panel it will stop and will not operate.
We recommend pulling timer knob off at least once a month and
cleaning assembly with compressed air to remove any and all
debris.
It is possible to break the knob if turned in the wrong direction.
Replacement knobs are available from AEI Corporation.
If timer fails to operate, we offer replacement timer with knob
which will require entire control panel, manifold, valve and timer
assembly to be removed and taken apart.
We also offer complete replacement control panel assemblies.
They include all the components attached to the control panels.
PART NUMBERS FOR REPLACEMENT CONTROL PANEL ASSEMBLIES FOR
THE TIMER UNITS ARE FOUND BELOW:
PART #: DESCRIPTION:
MTA27N T27NG CONTROL PANEL/MANIFOLD/VALVE/TIMER ASSB
MTA27L T27LP CONTROL PANEL/MANIFOLD/VALVE/TIMER ASSB
MTA36N T36NG CONTROL PANEL/MANIFOLD/VALVE/TIMER ASSB
MTA36L T36LP CONTROL PANEL/MANIFOLD/VALVE/TIMER ASSB
NOTE: Refer to the page 25 and 26 parts call-out for individual parts
replacement. Below are not called out or listed on that diagram.
MANIFOLD ONLY FOR TIMER UNITS: S27T=427713; S36T=436713
PANEL ONLY FOR TIMER CONTROL: S27T=427715; S36T=436715
1 HOUR TIMER (ALL LEGACY): 400960 (WA312)
TIMER KNOB ONLY W/SET SCREW: 400765 (WA KNOB 16)
HEAT SHIELD FOR TIMER: 400964
LEGACY T SERIES KNOBS WITH SET SCREW
Please note that PGS Legacy TIMER grills have “theft
resistant” knobs. The control valve knobs are secured
with a small Philips Head screw and the timer control knob
is secured with a small Allen screw.
Loading ...
Loading ...
Loading ...