Loading ...
Loading ...
Loading ...
12
For the Installer
7. CONTROLS
7.1 ELECTRICAL CONNECTION TO OPTIONAL CONTROLS
• Use the terminal connector included in the installation kit to perform the electrical
connection for main and optional wall controls.
• Make sure all wires are correctly inserted in their corresponding holes in the terminal
block. A wire is correctly inserted when its orange receptacle is lower than another one
without wire. On picture beside, wire A is correctly inserted, but wire B is not.
⚠ WARNING
Always disconnect the unit before making any connections. Failure in disconnecting power could result in
electrical shock or damage of the wall control or electronic module inside the unit.
CAUTION
Never install more than one optional main wall control per unit. Make sure that there are no short-circuit between
the wires or with any other components on the wall control. Avoid poor wiring connections. To reduce electrical
interference (noise) potential, do not run wall control wiring next to control contactors or near light dimming
circuits, electrical motors, dwelling/building power or lighting wiring, or power distribution panel.
VE0272
A
B
Use the chart below to verify compatibility with optional controls before making any connection.
Main Controls Auxiliary Controls
K7 ERV, K8 HRV, K10 HRV
• Altitude
• Deco-Touch
• Lite-Touch Constructo
• Simple Touch Constructo
• Constructo
• 20/40/60-minute push-button timer
• 20-minute lighted push button
• 60-minute crank timer
• Dehumidistat
40E, 40H+, 50H
• Platinum
• Deco-Touch
• Lite-Touch Bronze
• Simple Touch Bronze
• Bronze
NO C NC I OC OL Y R G B
VE0181
SMART
SET
MODE
PREF
NO C NC I OC OL Y R G B
VE0250
7.1.1 ALTITUDE OR PLATINUM 7.1.2 DECO-TOUCH
Loading ...
Loading ...
Loading ...