Loading ...
Loading ...
Loading ...
Replace the in-line filter if it becomes clogged and stops
the flow of fuel to the carburetor.
1. Let the engine cool.
2. Remove the in-line fuel filter (B) and seal the fuel line
sections with plugs.
3. Put the new in-line fuel filter in position in the fuel
line with the arrow pointing to the carburetor.
4. Make sure that there are no fuel line leaks and that
the clamps (A) are in the correct position.
5. If you spill, immediately clean the product.
A
B
To remove the air from the
transmission
CAUTION: Do not engage or disengage
freewheel lever when the engine is in
operation.
To keep high performance, remove the air in the
transmission before you operate the product for the first
time.
If you replace the transmission, remove the air in the
new transmission before you operate the product.
1. Park the product on a level surface that is clear and
open.
2. Stop the engine and engage the parking brake.
3. Put the freewheel control in the disengaged position.
Refer to
Transportation on page 34
.
4. Start the engine. When the engine has started,
move the throttle control to the slow position and
disengage the parking brake.
5. Do the steps that follow 3 times.
Note: During this procedure, there can be
movement of the drive wheels.
a) Push the forward drive pedal to the full forward
position and keep it pushed down for 5 seconds
before you release it.
b) Push the reverse drive pedal to the full reverse
position and keep it pushed down for 5 seconds
before you release it.
6. Stop the engine and engage the parking brake.
7. Put the freewheel control in the engaged position.
Refer to
Transportation on page 34
.
8. Sit in the seat and start the engine. When the engine
has started, move the throttle control to the half
speed position.
9. Disengage the parking brake.
10. Operate the product forward for approximately 5
ft (1.5 m) then rearward for 5 ft (1.5 m). Do this
procedure 3 times.
1720 - 004 - 22.09.2023
29
Loading ...
Loading ...
Loading ...