Loading ...
Loading ...
Loading ...
7. Install the battery. Refer to
To replace the battery on
page 23
.
To replace the battery
The battery is installed below the seat.
WARNING: Risk of electrical shock and
burn injuries. Do not use metal wristbands
or other metal accessories. Metal items that
touch the battery terminals can cause burn
injuries, electrical shock, and short circuit of
the battery.
1. Stop the product. Refer to
To stop the product on
page 15
.
2. Open the engine cover.
3. Remove the terminal covers (A).
A
4. Remove the bolt and the nut to disconnect the
black (negative) battery cable from the negative (-)
terminal.
WARNING:
Risk of electrical shock
and burn injuries. The black (negative)
battery cable must be disconnected
before you disconnect the red (positive)
battery cable.
5. Remove the bolt and the nut to disconnect the red
(positive) battery cable from the positive (+) terminal.
6. Carefully remove the battery from the product.
7. Install a new battery.
8. Connect the red (positive) battery cable to the
positive (+) terminal and tighten the bolt and the nut.
WARNING:
Risk of electrical shock
and burn injuries. The red (positive)
battery cable must be connected to the
positive (+) terminal before the black
(negative) battery cable is connected to
the negative (-) terminal to prevent injury
and accidental grounding.
9. Connect the black (negative) battery cable to the
negative (-) terminal and tighten the bolt and the nut.
10. Install the terminal covers.
11. Close the engine cover.
To connect the jumper cables
WARNING: Risk of explosion because
of explosive gas that comes from the
battery. Do not connect the negative
terminal of the charged battery to or near the
negative terminal of the weak battery.
CAUTION: Do not use the battery of
your product to start other vehicles.
1. Connect one end of the red battery cable to the
POSITIVE (+) battery terminal (A) on the weak
battery.
B
A
C
D
2. Connect the other end of the red battery cable to the
POSITIVE (+) battery terminal (B) on the charged
battery.
WARNING:
Do not let the ends of
the red battery cable touch the chassis.
This will cause a short circuit.
3. Connect one end of the black battery cable to the
NEGATIVE (-) battery terminal (C) on the charged
battery.
4. Connect the other end of the black battery cable to
a CHASSIS GROUND (D), away from the fuel tank
and the battery.
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
1720 - 004 - 22.09.2023
23
Loading ...
Loading ...
Loading ...