Loading ...
Loading ...
Loading ...
4 Quick Start
4.1 Unpacking
Unpack the calibrator carefully and inspect it for any damage that may have oc
-
curred during shipment. If there is shipping damage, notify the carrier
immediately.
Verify that the following components are present:
•
9009 Dry-well
•
Two 3102-3 ( 3/16”) and two 3102-4 (1/4”) Inserts
•
Power Cord
•
Report of Calibration with calibration label
• User’s Guide
• 9930 Interface-it Software and User’s Guide
• RS-232 Cable
• Insert Removal Tool
4.2 Set-Up
Place the calibrator on a flat surface with at least 18 inches above the instru-
ment. Plug the power cord into a grounded mains outlet. Observe that the nomi-
nal voltage corresponds to that indicated on the calibrator.
Carefully insert the probe sleeves into the wells. (DO NOT drop the sleeve in
the well.) Probe sleeve holes should be of the smallest diameter possible while
still allowing the probe to slide in and out easily. Sleeves with various hole
sizes are available from Hart Scientific. The well must be clear of any foreign
objects, dirt and grit before the sleeve is inserted. The sleeve is inserted with
the small tong hole positioned upward.
Turn on the power to the calibrator by toggling the switch on the power entry
module. The fan should begin quietly blowing air through the instrument and
the controller displays should illuminate after 3 seconds. After a brief self test
the controller should begin normal operation. If the unit fails to operate please
check the power connection.
The displays will begin to show the well temperature and the well heater and
TEDs will start operating to bring the temperature of the wells to the set-point
temperatures.
4.3 Power
Plug the calibrator power cord into a mains outlet of the proper voltage, fre
-
quency, and current capability. Refer to Section 3.1, Specifications, for power
11
4 Quick Start
Unpacking
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...