Loading ...
Loading ...
Loading ...
17
Drill holes in Rear Wall
1. The mounting plate is located inside the outer foam in the
cavity, take it out.
B
A
A. Mounting Plate
B. Outer Foam in the Carton
2. Attach the mounting plate to wall. Make sure the 4 holes on
mounting plate align with the A, B, H & J holes marked in the
“Mark Rear wall” section and the mounting plate center
markers align with the Center Mark.
NOTE: It may be necessary to use a number of the spacers,
between the mounting plate and the wall, to achieve a more
‘Flush’ appearance. See “Attach Mounting Plate to Wall”
section for more details.
Measure from the back wall to where the front bottom surface
of the microwave oven needs to determine the number of
spacers needed.
A
B
C
D
E
A. Mounting Plate
B. A & B & H & J holes
C. Mounting Plate Bottom Line
D. Center Mark
E. Mounting plate center markers
3. Drill holes at A, B, H, & J, if the Wall studs are not located A &
B hole, do not drill A & B hole, and follow the below instruction.
In addition to being installed on at least 1 wall stud, the
mounting plate must attach to the wall at both end holes. If the
end holes are not over wall studs, use two 3/16-24 x 3" round
head bolts with toggle nuts; if 1 end hole is over a wall stud,
use 1 lag screw and one 3/16-24 x 3" round-head bolt with
toggle nut; or if both end holes are over wall studs, use 2 lag
screws. Following are 3 installation configurations.
Installation for No Wall Studs at End Holes
(Figures 1 and 2 in Find the Wall Stud(s) section)
1. Drill 5/8" (1.6 cm) holes through the wall at both end holes
marked in Step 3 of the “Mark Rear Wall.”
2. Drill 3/16" (5 mm) hole(s) into the wall stud(s) at the
hole(s) marked in step 6 of the “Mark Rear Wall.” Refer to
figures 1 and 2 in “Possible Wall Stud Configurations” in
the “Locate Wall Studs(s)” section.
Installation for Wall Stud at One End Hole
(Figure 3 in Find the Wall Stud(s) section)
1. Drill a 3/16" (5 mm) hole into the wall stud at the end hole
marked in Step 3 of the “Mark Rear Wall.”
2. If installing on a second wall stud, drill a 3/16" (5 mm) hole
into the wall stud at the other hole marked in Step 6 of the
“Mark Rear Wall.” Refer to Figure 3 in “Possible Wall Stud
Configurations” in the “Locate all Stud(s)” section.
3. Drill a 5/8" (1.6 cm) hole through the wall at the other end.
Installation for Wall Studs at Both End Holes
(Figure 4 in Find the Wall Stud(s) section)
1. Drill 3/16" (5 mm) holes into the studs at the end holes
marked in Step 3 of the “Mark Rear Wall.”
4. Using a keyhole saw, cut out the rectangular wall venting
cutout area. Skip this step if for recirculation venting or roof
venting installation.
A
A. Wall Venting Cutout Area
Loading ...
Loading ...
Loading ...