Loading ...
Loading ...
Loading ...
16
4. Find and mark the two bottom position lines (A) on the
cardboard plate.
A
A. Cardboard Plate Bottom Position Line
5. Using the bottom edge of the cardboard plate, align it with the
two small lines (A), and draw a line (B) indicating where the
bottom edge of the mounting plate (C) should be.
A
B
C
A. Two Small Lines
B. Cardboard Plate Bottom Line
C. Bottom Edge of Mounting Plate
6. Draw four small circles using the A, B, H, and J holes.
A & B & H & J holes
Drill holes in Upper Cabinet
1. Using a drill and the 3/4" (1.9 cm) hole saw, cut out the power
cord hole (A).
2. Drill two mounting nut holes (B), which are 3/8" (10 mm) holes
at points “D” and “E” on the cardboard template. These are for
two 1/4-20 x 3" bolts and washers used to secure the
microwave oven to the upper cabinet.
A
B
A. Power Cord Hole
B. Mounting Nut Holes
NOTE: If upper cabinet is metal, the supply cord bushing
needs to be installed around the supply cord hole as shown.
A
B
A. Metal cabinet
B. Power supply cord bushing
3. Using a keyhole saw, cut out the rectangular roof venting
cutout area. Skip this step if for recirculation venting or wall
venting installation.
A
A. Roof Venting Cutout Area
Loading ...
Loading ...
Loading ...