Loading ...
Loading ...
Loading ...
12
TECHNICAL FEATURES OF YOUR OVEN
SPECIFICATIONS 90x60
Outer Width 900mm
Outer Depth 610mm
Outer Height 925mm
Lamp Power 15W
Bottom Heating Element 2000W
Top Heating Element 1500W
Grill Heating Element 2500W
Turbo Heating Element 1250W x 2
Supply Voltage 220-240V AC/380-415V AC 50/60Hz
Hotplate 145mm* 1000W
Hotplate 180mm* 1500W
Hotplate Rapid 145mm* 1500W
Hotplate Rapid 180mm* 2000W
REDUCED GAS FLOW RATE SETTING FOR HOB TAPS
1. Ignite the burner that is to be adjustment and
turn the knob to the reduced position.
2. Remove the knob from the gas tap.
3. Use an appropriately sized screwdriver to adjust
the ow rate adjustment screw. For LPG (Butane-Pro
pane) turn the screw clockwise. For the naturel gas,
you should turn the screw counter- clockwise once.
“The normal length of a straight ame in the
reduced position should be 6-7 mm.“
4. If the ame is higher then the desired
position, turn the screw clockwise. If it is smaller
turn anticolockwise.
5. For the last control, bring the burner both
to higt-ame and reduced positions and check
whether the ame is on or off.
Depending on the type of gas tap used in your
appliance the adjustment screw position may vary.
To adjust your oven acc. to the gas type, make the adjustment for reduced
ame carefully by turning with a small screwdriver as shown below on the screw
in the middle of the gas cocks as well as nozzle changes. (Figure 3 and 4)
Figure 3
Figure 4
GB
Loading ...
Loading ...
Loading ...