Hikvision DS-K1T502DBWX-C User Manual

Loading ...

Note

If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set

the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address

according to the door No.

Baud Rate

The baud rate when the devices are communicang via the RS-485 protocol.

Output Type

If you select Access Controller as the peripheral type, you should set the parameter. The device

will output the card No. or the employee ID to the access controller.

Click Save to save the

sengs.

Set Wiegand Parameters

You can set the Wiegand transmission direcon.

Steps

Note

Some device models do not support this funcon. Refer to the actual products when conguraon.

Click Conguraon → Access Control → Wiegand Sengs .

Check Wiegand to enable the Wiegand funcon.

Set a transmission direcon.

Output

The can connect an external access controller. And the two devices will transmit the card No.

via Wiegand 26 or 34.

Drag the block to set the

me interval and pulse width.

Note

●

The me interval ranges from 1 ms to 20 ms.

●

The pulse width ranges from 1 us to 100 us.

Click Save to save the sengs.

Note

If you change the peripheral, and aer you save the device parameters, the device will reboot

automacally.

DS-K1T502 Series Access Control Terminal User Manual

Loading ...

Hikvision DS-K1T502DBWX-C Access Control Terminal