Loading ...
Loading ...
Loading ...
MESH DUST FILTER MAINTENANCE
Checking the Mesh Dust Filters:
When the mesh dust filters need maintenance, the front display will show the following screen with a pulsing red ring:
Cleaning the Mesh Dust Filters:
When the Check Dust Filters message appears on the front display, remove the dust filters and inspect them for debris.
If maintenance is required, be sure to KEEP THE AIR PURIFIER PLUGGED IN and running, and complete the following steps:
Gently slide up the filters to remove
them. Check the screens for dust and
debris buildup.
Use a vacuum cleaner on low speed with
a soft brush attachment OR a cloth/towel
to remove debris from the mesh screens.
DO NOT use abrasive chemical cleaners.
If additional cleaning is required, rinse the
mesh dust filters with room temperature
tap water. Be sure to completely dry the
screens for 12 hours before reinstalling.
DO NOT USE the air purifier when mesh
filers are wet.
Gently reinsert the mesh dust filters into the
slots on the sides of the air purifier. Be sure
to push each dust filter into place until it is
flush with the air purifier body.
Once both mesh dust filters have been
cleaned and reinstalled, the air purifier will
recalibrate and begin to analyze air quality,
indicated by the rotating lights.
1. LOCATE AND REMOVE
MESH DUST FILTERS
4. REINSTALL MESH DUST FILTERS
2. CLEAN DUST FILTERS
5. RECALIBRATION
3. ADDIITONAL CLEANING
(NOT REQUIRED)
Note: The NeverChange HEPA Filter Technology allows up to 5 years* of use out of a single HEPA filter.
*Tested to GB/T18801-2015 P.CCM, based on 50% CADR declined, 300 sq. ft. cleaning area and 12 hours daily operation on MAX fan speed.
Note: To manually reset the Check
Dust Filters indicator, press and hold
the filter icon on the top control panel
for 1.5 seconds.
Loading ...
Loading ...
Loading ...