Loading ...
Loading ...
Loading ...
17
Parts and Controls
Back Panel
Parts and Controls 7
The user should become familiar with the bath and its parts:
Back Panel 7.1
Figure 1 on this page.
Power Cord – On the back of the calibrator is the removable power cord inlet that
plugs into an IEC grounded socket.
~
115/230 V - 5 A F 250 V
POWER
115/230 V A C
400 W 50/60 Hz
201811
FLUKE CORPORATION
HART SCIENTIFIC DIVISION
www.hartscientific.com
RS-232
DISPLAY
HOLD
Figure 1 7103 Back Panel and Bottom
Power Switch – The power switch is located on the power entry module (PEM). The
PEM also houses the fuses.
Serial Port – A DB-9 male connector is present for interfacing the calibrator to a
computer or terminal with serial RS-232 communications.
Fan – The fan inside the calibrator runs continuously when the unit is being op erated
to provide cooling for the instrument. However, the fan slows down when heating
or at high temperatures. Slots at the top and around the two cor ners of the calibrator
are provided for airow. The area around the calibrator must be kept clear to allow
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...