Loading ...
Loading ...
Loading ...
EN
©2021 Hestan Commercial Corporation
19
INSTALLATION
(continued)
Typical indoor installation
beneath a wall oven.
HOLES FOR
MOUNTING
FRAME
PLACING THE DRAWERPLACING THE DRAWER
NOTE: The unit is heavy and requires at least two people or proper equipment to move. Verify
there is room to run the power cord before placing the drawer without pinching it.
1. As shown on the previous page, the electrical outlet may be located directly behind the unit, or
in a nearby adjacent cabinet opening. If the plug will not be accessible after placing the unit,
turn power OFF at the service panel. Lock service panel to prevent power from being turned
ON accidentally.
2. Run the cord through to the outlet.
3. Position the drawer so that it is directly centered and slide the warming drawer assembly into
the cutout until it is flush with cabinet face.
4. Securely fasten the drawer mounting frame to the cabinet in all four corners using the wood
screws provided.
CAUTION
Failure to secure the warming drawer could result in the drawer moving
or tipping during use and causing damage to the drawer or cabinets or
personal injury.
5. Turn the power back on or plug in the unit.
6. Test operation of the unit (see page 9). Observe that the interior light comes on. Operate the
unit for approximately 5 minutes, then check for warmth.
7. After verifying that the drawer is warming up, turn the unit OFF.
• Make sure that the customer knows how to disconnect the power to the warming drawer at
the circuit breaker or fuse box in case of an emergency.
Loading ...
Loading ...
Loading ...