Loading ...
Loading ...
Loading ...
EN
©2021 Hestan Commercial Corporation
13
CLEANING AND MAINTENANCE
(continued)
CLEANINGCLEANING
The only recommended maintenance for the Warming Drawer is cleaning.
Before you begin cleaning, turn the appliance OFF and disconnect the appliance from the outlet or
shut off the breaker. Allow the appliance to cool before cleaning it.
NOTICE
Do not use harsh detergents or abrasive products and/or scrubbing pads and sponges and sharp
objects as they can stain and damage the appearance of the appliance.
Never use a vacuum cleaner on the internal parts of the appliance.
FRONT SURFACE AND CONTROL PANELFRONT SURFACE AND CONTROL PANEL
The use of a moist cloth is often sufficient when cleaning the appliance. If needed, add a few drops
of liquid detergent in the water. Dry the appliance with a dry cloth. The stainless steel front of
the appliance can be cleaned with products specifically designed for stainless steel. Such products
prevent the formation of dirt on the surface of the drawer. Apply a minimal amount of the product
on a soft cloth and apply it to the surface of the appliance.
Clean the control panel ONLY with a cloth moistened with plain water. The special plastic surface
may discolor or become opaque if you use any harsh cleaners.
If your Hestan appliance has a colored drawer panel, use warm soapy water ONLY. Rinse and dry
thoroughly.
DRAWER INTERIORDRAWER INTERIOR
Use a moist cloth to clean the drawer interior. In the event the appliance requires further cleaning
add drops of detergent to the water. Dry the surface with a dry cloth. Make sure to avoid
excessive water entering into the moisture control vents on the inside face of the drawer, or the
heating louvers and fan openings at the rear wall of the drawer cavity. Only use the appliance after
the drawer is completely dry.
The silicone rubber mat can be cleaned with mild detergent and water.
REPLACING A WARMING DRAWER LIGHT BULBREPLACING A WARMING DRAWER LIGHT BULB
The Warming Drawer is equipped with a halogen light located on the right side of the unit.
ELECTRICAL SHOCK HAZARD - Make sure the power has been shut off to the Warming Drawer.
The light socket is energized when the drawer is open. Failure to shut off the power when
replacing a light bulb could result in electric shock or burns.
Make sure the glass lens is cool to the touch. Use care when handling the lens, it is fragile and can
break if dropped.
Use only 20 watt, 12 volt, halogen “Bi-Pin” bulbs suitable for appliance use. This type of bulb may
be available at hardware stores & home centers, or specialty lighting stores. Call Hestan Customer
Care for more information.
Loading ...
Loading ...
Loading ...