Loading ...
Loading ...
Loading ...
The interior assembly comes with the pre-in-
stalled wired door sensor setup for a right
swing doors with 2 ¾" (70mm) backset*.
Trim excess part (P) for doors with 2 ⅜"
(60mm) backset as shown below.
For left swing doors, re-route the door
sensor wire through the side channel.
Pull the foam pad then re-insert to
secure the wire. Discard the excess
part (e) for doors with 2 ⅜" (60mm)
backset as shown below:
*Backset = distance of the door edge to the center of the cross-bore door hole.
DO NOT INSTALL THE SENSORS YET
Pull foam pad Insert form pad
PREPARING DOOR SENSORS FOR INSTALLATION
3
2
1
(P)
10
Step 4
continued
Trim excess here for
2 ⅜" (60mm) backset*
Loading ...
Loading ...
Loading ...