Loading ...
Loading ...
Loading ...
6
Note: The MID200 dispenser has a bin thermostat in place for use when the dispenser is
combined with a curtain switch controlled ice machine. This thermostat must be wired
in series with the ice machine curtain switch to maintain the proper ice level in the bin. If
this is not done, the bin may overfill and cause damage to the dispenser and ice machine.
See additional instructions for this connection.
• Remove the large access cover on the right side of the dispenser.
• With the right side ice machine panel removed, locate, cut and remove the wire tie on the
bracket near the curtain switch.
• Remove the wire from the common terminal of the switch, cut the terminal connector from
this wire and strip the end of the wire .300”.
• Using the wire assembly provided with the dispenser, slip the red insulated connector on the
common terminal of the curtain switch. Join the end of the other wire provided with the wire
removed from the curtain switch and apply the closed end connector provided.
• Secure these wires to the bracket near the curtain switch with the wire tie provided.
• Run the wire ends down to and through the hollow bolt into the ice dispenser.
• Insert the wire ends into the top end of the plastic tube, next to the dispenser controls, and
push the wires through the tube down to the bin thermostat switch.
• Attach the two spring spade connectors to the wire ends and attach the wires to the switch.
Loading ...
Loading ...
Loading ...