Loading ...
Loading ...
Loading ...
3. Use (C) to display the setting you want to
change.
●
Each press of (C) cycles through
settings in the sequence shown below.
Day
Month
Ye a r
Minutes
Hours
Seconds
Summer time
4. Configure the date and time settings.
●
While the seconds are flashing,
pressing (D) will reset them to 00. 1 is
added to the minutes when the current
seconds count is between 30 and 59
seconds.
●
For all the other settings, use (B) and (D)
to change the flashing setting.
Holding down (B) or (D) scrolls through
settings at high speed.
5. Repeat steps 3 and 4 to select time and
date settings.
6. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
To switch the digital time between 12-
hour and 24-hour timekeeping
You can select either 12-hour or 24-hour
timekeeping for the digital time.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Each press of (D) toggles between 12-
hour and 24-hour timekeeping.
●
[A] (a.m.) or [P] (p.m.) is displayed for
times when 12-hour timekeeping is
being used.
●
To configure the digital time summer
time setting
If you are in an area that observes summer
time, you can also enable or disable summer
time.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least one second.
Release the button when the seconds
start to flash.
Seconds
3. Press (C).
4. Use (D) to change the summer time
setting.
●
[OFF]
The watch always indicates standard
time.
●
[ON]
The watch always indicates summer
time.
5. Press (A) to complete the setting
operation.
●
[DST] is shown on the display to
indicate summer time.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Adjusting the Current Analog
Time Setting
1. Enter the Hand Setting Mode.
l
Navigating Between Modes
2. Hold down (A) for at least one second.
Release the button when the current time
starts to flash on the digital display.
3. Press (D).
●
Each press advances the time setting
1/3 of a minute (20 seconds).
●
Holding down (D) advances the hands
at high speed.
●
Pressing (B) and (D) at the same time
advances the time setting up to 12
hours at high speed. To stop the high-
speed operation at any time, press any
button.
4. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 5699
7
Loading ...
Loading ...
Loading ...