Sealey SA372 Tyre Inflator 0.5m Hose User Manual

Tyre InflaTor 0.5m Hose wITH TwIn

PusH-on CHuCk, Tyre InflaTor 2.7m

Hose wITH ClIP-on ConneCTor

Model no: sa371, sa372

Thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these

instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR

PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1. safeTy

9  Disconnectthetyreinatorfromtheairsupplybeforechangingaccessories,servicingorperforminganymaintenance.

9  Keepchildrenandunauthorisedpersonsawayfromtheworkarea.

9  Keepthegaugescreenandtyreinatorclean.

9  ReplacedamagedpartswithgenuineSealeyparts.Unauthorisedpartsmaybedangerousandwillinvalidatethewarranty.

9  Checkconditionofthebatteriesregularly.

9  Checktyrepressureswhentheyarecold.

8 Do noTdirectthetyreinatoroutletatyourselforothersincludinganimals.

8 Do noTcarrythetyreinatorbythehose,ortugthehosefromtheairsupply.

8 Do noTusethetyreinatorforataskwhichitisnotdesignedtoperform.

8 Do noToperatethetyreinatorwhenyouaretiredorundertheinuenceofintoxicatingmedicines,drugsoralcohol.

8 Do noToperatethetyreinatorifpartsaremissingortheLCDisdamaged,thiscouldbedangerous.

8 Do noTdroporbumpthetyreinator.

8 Do noTgetthetyreinatorwet.

8 Do noToperatenearapplianceswithstrongmagneticelds,corrosivegassesorcorrosiveliquids.

2. InTroDuCTIon

2.1. sa371

ManufacturedtocomplywithEN12645.Aluminiumbodywithrubberbumper.Linearpressurescale,dualcalibratedinpsiandbar,with

parallaxcorrection.0.5mFlexiblehosettedwith240mm,twinpush-onairconnector.Suppliedwithaserialnumberedcalibrationcerticate.

2.2. sa372

ManufacturedtocomplywithEN12645.Aluminiumbodywithrubberbumper.Linearpressurescale,dualcalibratedinpsiandbar,with

parallaxcorrection.2.7mFlexiblehosettedwith240mmclip-onairconnector.Suppliedwithaserialnumberedcalibrationcerticate.

3. sPeCIfICaTIon

model no:.............................................................................sa371 ....................................................................... sa372

InletSize:........................................................................... 1/4”BSP.....................................................................1/4”BSP

MaximumAirSupply:.................................................15bar(218psi)............................................................ 15bar(218psi)

MinimumAirSupply:...................................................5.5bar(80psi)............................................................. 5.5bar(80psi)

nettWeight:..........................................................................1.15kg....................................................................... 1.15kg

Range:............................................................... 0-9.5bar(0-138psi).....................................................0-9.5bar(0-138psi)

HoseLength:............................................................................0.5m.......................................................................... 2.7m

Connection:..................................................... TwinPush-onChuck......................................................................Clip-on

4. oPeraTIon

4.1. To reaD Pressure

4.1.1. Placehold-onchucksquarelyandrmlyontotyrevalve,beforeeachpressurereadingfullydepressleverandrelease.

4.2. To InflaTe

4.2.1. Placechucksquarelyandrmlyontothevalve.Fullydepressleverforanappropriateperiodthenreleaselevertodisplay 

 pressure.Checkpressuregaugeandrepeatprocedureuntilcorrectpressurelevelisachieved.

4.3. To DeflaTe

4.3.1. Depressleverhalfway(untilaircanbeheardescaping)foranappropriateperiod,fullydepresslevermomentarilythenreleaseto

 displaynewpressure.Checkpressuregaugeandrepeatprocedureuntilcorrectpressurelevelisachieved.

SA371SA372Issue120/06/19

Original Language Version

©JackSealeyLimited

Referto

instructions

5. maInTenanCe

5.1. PerIoDIC CHeCks anD maInTenanCe

 Forlongserviceandaccuracy,thefollowingactionsshouldbecarriedoutattherecommendedintervals.

5.2. weekly - CHeCk oPeraTIon

 Thegaugeshouldbecheckedweeklyforcorrectoperation.Lookforsmoothleveroperationandfast,smoothgaugemovements.

 Checkforleaksfromtyreconnectorseals,andforchangorwearoftheexiblehoses.Removefromserviceifdamaged.

5.3. monTHly

 Removeoilscrew(g.1)place2-3dropsoflightoilintothegaugemechanism.

6. TroublesHooTIng

 Thisairlinegaugehasbeenengineeredtogiveyearsoftrouble-freeservice.Majorfaultsareoftendueeithertoprolonged 

 mistreatmentortoadirty,excessivelywetairsupply.Thefollowingguidewillenabletheoperatororserviceengineertodiagnose

 andcureanyproblemswhichmayarise.

6.1. aIr leaks from Tyre ConneCTor

 Thesealsshouldbereplacedwhenitbecomesdi󰀩culttoobtainaneasy,positiveairtightsealonatyrevalve.Newchucksare 

 availablefromSealeyStockists.

6.2. DamageD flexIble Hose (gauge To Tyre ConneCTor)

 Thecompletehoseassemblyshouldbereplacedimmediatelyifanysignofdeepchangorcrackingappears.Ensurethatthe 

 centredlterinthegaugeoutletportdoesnotbecomedislodgedduringreplacement.

6.3. erraTIC HIgH gauge reaDIngs or sTIff, jerky lever oPeraTIons

 Causedbyasti󰀨ordamagedvalveassembly.Ifnotcuredbyoilingthevalvemechanismthenreplacethevalveassembly.

6.4. slow Tyre InflaTIon

 Causedby:Lowsupplypressure,orblockedinletlter,ordamagedvalvemechanism.

6.5. erraTIC low gauge reaDIngs anD/or sluggIsH gauge oPeraTIon - gauge Does noT reTurn To zero

 Causedbysti󰀨ordamagedgaugemechanism.Thegaugemustbereturnedtoanauthorisedrepaircentreasspecialequipmentis

 requiredtore-checkthecalibrationofthegaugeafterrepair.

Oil Point

g.1

CalIbraTIon CerTIfICaTe

Tyre InflaTer

Model no: sa371, sa372

Thistyreinaterhasbeencalibratedinitsnormalworkingpositionontestequipmentwithanaccuracythatistraceabletostandards

accordingto:EN12645:2014.(Tyrepressuremeasuringinstruments,devicesforinspectionofpressureand/orInation/deationoftyresfor

motorvehicles.)

PhysicalLaboratoryReferenceNumberL0134,ReferencePressureIndicatorKeyenceAP-C33,SerialNumberE031759.

serial no.

Date:

sealey group, kempson way, suffolk business Park, bury st edmunds, suffolk. IP32 7ar

01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk

envIronmenT ProTeCTIon

Recycleunwantedmaterialsinsteadofdisposingofthemaswaste.Alltools,accessoriesandpackagingshouldbesorted,takento

arecyclingcentreanddisposedofinamannerwhichiscompatiblewiththeenvironment.Whentheproductbecomescompletely

unserviceableandrequiresdisposal,drainanyfluids(ifapplicable)intoapprovedcontainersanddisposeoftheproductandfluids

accordingtolocalregulations.

note:Itisourpolicytocontinuallyimproveproductsandassuchwereservetherighttoalterdata,specificationsandcomponentpartswithoutprior

notice.

Important:NoLiabilityisacceptedforincorrectuseofthisproduct.

warranty:Guaranteeis12monthsfrompurchasedate,proofofwhichisrequiredforanyclaim.

reference pressure psi 29.0 58.0 87.0 116.0

allowable Tolerances +/-1.2psi +/-1.2psi +/-2.3psi +/-2.3psi

Indicated pressure psi

TesT resulTs

SA371SA372Issue120/06/19

Original Language Version

Sealey SA372 Tyre Inflator 0.5m Hose

Product's Documents

Instructions

Specifications

Sealey SA372 Questions and Answers