H80CIMWAD Owner's Guide

Loading ...

PERLICK RESIDENTIAL UNDERCOUNTER CUBELET ICE MAKER PRODUCT MANUAL

perlick customer service (800)558-5592 | 21

ELECTRICAL CONNECTION

Electrical connecon must meet naonal,

state, and local electrical code requirements. Failure to meet

these code requirements could result in death, electric shock,

serious injury, re, or damage.

The appliance requires an independent

power supply of proper capacity. See the nameplate for

electrical specicaons. Failure to use an independent power

supply of proper capacity can result in a tripped breaker,

blown fuse, damage to exisng wiring, or component failure.

This could lead to heat generaon or re.

THE APPLIANCE MUST BE GROUNDED:

The appliance is equipped with a NEMA 5-15 three-prong

grounding plug to reduce the risk of potenal shock hazards.

It must be plugged into a properly grounded, independent

3-prong wall outlet. If the outlet is a 2-prong outlet, it is your

personal responsibility to have a qualied electrician replace

it with a properly grounded, independent 3-prong wall outlet.

Do not remove the ground prong from the power cord and

do not use an adapter plug. Failure to properly ground the

appliance could result in death or serious injury.

Do not use an extension cord.

To reduce the risk of electric shock, do not

touch the control switch or plug with damp hands. Make sure

the control switch is in the “OFF” posion before plugging in

or unplugging the appliance.

Do not use an appliance with a damaged

power cord. The power cord should not be altered, jerked,

bundled, weighed down, pinched, or tangled. Such acons

could result in electric shock or re. To unplug the appliance,

be sure to pull the plug, not the cord, and do not jerk the

cord.

The GREEN ground wire in the factory-

installed power cord is connected to the appliance. If it

becomes necessary to remove or replace the power cord, be

sure to connect the power cord’s ground wire to this screw

upon reaachment.

Usually an electrical permit and services of a licensed

electrician are required.

The maximum allowable voltage variaon is ±10 percent of the

nameplate rang.

For oponal drain pump (63802A) installaon, refer to the

instrucons included with the pump.

DANGER

Loading ...

Owner's Guide - Page 21