Loading ...
Loading ...
Loading ...
6
Introduction (continued)
This product is designed to be used indoors.
This product is not operable outdoors. Do not expose this
product to direct sunlight for hours and do not install the
product near a heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and malfunction.
Keep this product away from water and moisture.
i-PRO Co., Ltd. assumes no responsibility for injuries
or property damage resulting from failures arising out
of improper installation or operation inconsistent with
this documentation or through use of parts other than
this product, such as locally procured parts.
Do not place this product in the following places:
• Locations exposed to direct sunlight
• Locations subject to having strong vibration or impact
• Locations near magnetic eld sources such as a
television or speakers
• Locations near the devices that emit large sound and
generate vibration by sound pressure
• Locations where condensation forms easily, where
temperature changes greatly or where humidity level is
high
• Locations subject to steam and oil smoke such as a
kitchen
• Locations which are not level
• Locations subject to dust
• Locations where it may get wet from rain or water splash
Do not install this product in locations where the
product or the cables can be destroyed or damaged
by persons with malicious intent.
In order to prevent injury, the product must be securely
mounted to a wall according to Installation Guide.
Place this product horizontally on a level surface.
Do not place this product in an upright position. When
stacking multiple recorders, clear a space of more than 5 cm
{2 inches} from both sides, the top, the bottom and the rear
of the recorders.
More than
5 cm {2 inches}
More than
5 cm {2 inches}
More than
5 cm {2 inches}
More than
5 cm {2 inches}
• Do not stack this product in a stack.
• Do not place anything that can generate vibration on the
top of this product.
Heat dissipation
To prevent this product from overheating, heed the
following. Failure to observe this may cause fire or trouble.
• Do not block the cooling fan outlet or the ventilation holes
with a wall, rack, cloth, etc. Maintain the product
periodically to prevent dust from blocking ventilation holes.
• The lifetime of the cooling fan is limited by use. It is
recommended to replace them after around 30000
hours of operation. Contact your dealer for replacement
of the cooling fans.
• When the internal temperature rises, the fan noise may
become louder.
• Clear a space of more than 5 cm {2 inches} from both
sides, the top, and the rear of the product. Do not block
the ventilation holes on the front side since this product
is designed to cool the hard disk drives by drawing in air
from the front.
Avoid placing this product near noise sources
If the cables are placed near noise sources such as
fluorescent lamps, noises may be produced. In this case,
rewire avoiding the noise sources, or move the product to a
place far from the source.
Grounding
Confirm that the wire is connected from the SIGNAL GND
terminal to earth ground.
A grounding connection must be made before connecting
the power plug or this product to the main power supply.
When disconnecting the grounding wire, make sure that the
power plug of this product is disconnected from the main
power supply.
Avoid placing receptacles that contain liquids such as
water near this product.
If liquid spills onto this product, it may cause fire or an
electric shock.
About sulfuration of rubber products
Do not leave rubber products containing sulfur (packing and
rubber feet) close to the recorder or in the same storing box.
Sulfur constituent from the rubber products may cause
sulfuration corrosion on electrical parts or terminals and
defects in the recorder.
Equipment classification and power source indication
label
Refer to the indication label on the bottom side of this unit
for the equipment classification, power source, and other
information.
Precautions for installation
Loading ...
Loading ...
Loading ...