Loading ...
Loading ...
Loading ...
Other faults
What if ... Possible fault Solution
The
program
runs too
long or
stops.
In some cases "Clean out airways" is displayed. Check all the
possible causes and open and shut the dryer door.
Ventilation to and from the
dryer may be insufficient
(e.g. because it is installed
in a small room). This has
caused the temperature in
the room to rise sharply.
Open a door or window while the
machine is in operation for increased air
flow.
The lint filter is clogged
with lint or were still wet
when they were replaced.
–
Remove the lint.
–
THe lint filters must be completely dry.
The vents below the door
are blocked.
– Remove any objects that are blocking
the vents.
The exhaust hose or the
connection is clogged with
lint or were still wet when
they were replaced.
– Check the exhaust parts regularly
(e.g. wall vent duct, louvered wall
vent, bends, etc.) for air permeability.
– Remove the lint.
– The filters must be completely dry.
Detergent residues, hair
and fine fibers can block
the heat exchanger.
Check the heat exchanger from time to
time and clean it if necessary.
The laundry was not spun
sufficiently in the washer.
Spin laundry thoroughly at the
appropriate speed before drying.
The dryer has
over-loaded.
Regard the maximum load size per
program.
Metallic zippers prevent a
correct measurement of
the laundry’s residual
moisture.
–
Open the zippers of the laundry
before drying.
If the problem persists, dry items with
long zippers using the "Warm air"
program.
The
laundry is
not dry
enough.
The load contained too
many dissimilar items (size
and fabrics.)
–
Continue drying using the "Warm air"
program.
–
See the "Program Guide" for suitable
programs.
Frequently asked questions
30
Loading ...
Loading ...
Loading ...