Loading ...
Loading ...
Loading ...
What if ... Possible cause Solution
At the end of a
program
Maintenance
message
or
Clean the heat
exchanger
appears
The dryer reminds you to
clean the heat
exchanger.
–
Clean the heat exchanger.
To delete this message:
–
Confirm with "OK".
You can adjust the
setting which controls
when or if the
Maintenance message
appears.
–
See "Settings - Supervisor level
- Cleaning the heat exchanger".
Clean out airways
The dryer does not work
at its optimum or not
efficiently.
Possible cause:
clogging by lint or
detergent residues.
–
Cleaning the lint filters in usually
all that is required. However, if
the Clean the airways message
does not go out after you have
cleaned them, then also check
all the possible causes
described under "The program
runs too long or stops.".
To delete this message:
– Confirm with "OK".
You can adjust the setting which
controls when or if the message
"Clean the airways" appears.
– See "Settings menu J. Clean the
airways".
Drain fault
The drain hose is kinked
–
Remove the kink
To delete the fault message:
–
Confirm with OK.
Program finish
time changed
This is not a fault. While the timer was counting
down, the settings were changed
or there was a power failure.
Frequently asked questions
29
Loading ...
Loading ...
Loading ...