Loading ...
Loading ...
Loading ...
English 21
Option 1
(Using the short
2 screws.)
Option 2
(Using the long
2 screws.)
2. Line up the holes on anti-tip bracket with the holes in
oor or the Wall plate as shown in Options 1 and 2.
Secure the bracket in place with a Phillips Screwdriver
and using two of the four screws provided.
Anti-Tip
bracket
Screw must enter wood.
Wall sill plate
*approximately
21/32" (16.5 mm)
Screw must enter wood or concrete.
3. Level range by adjusting the leveling legs with a wrench.
Use a spirit level to check your adjustments. Plug the power supply cord into the grounded outlet. Slide range
back into position. To check visually that rear leveling leg is inserted into bracket, grasp the top rear edge of
the range and carefully attempt to tilt it forward.
Leveling leg
Leveling leg
Anti-Tip bracket
NOTE
To install the Anti-tip bracket, release the leveling leg using pipe wrench because Loctite is applied on Bolt for
vibration unlocking. A minimum clearance of 21/32” (16.5 mm) is required between the range bottom and the
kitchen oor.
To check if the bracket is installed and engaged properly, remove the kick panel and look underneath the range
to see that the leveling leg is engaged in the bracket. Carefully tip the range forward. The bracket should stop the
range within 4 inches (10.2 cm) of tipping. If it does not, the bracket must be reinstalled.
If the range is pulled from the wall for any reason, always repeat this procedure to verify the range is properly
secured by the anti-tip bracket. Never completely remove the leveling legs or the range will not be secured to
the anti-tip device properly.
INSTALL_DOP36C86DLS_DA_DG68-01510A.indb 21INSTALL_DOP36C86DLS_DA_DG68-01510A.indb 21 2023-02-23 오전 9:57:432023-02-23 오전 9:57:43
Loading ...
Loading ...
Loading ...