Loading ...
Loading ...
Loading ...
5
This appliance should be properly grounded for
your safety. The power cord of this appliance is
equipped with a three-prong plug which mates
with a standard three-prong wall outlet to
minimize the possibility of electrical shock.
Do not under any circumstance cut or remove
the third (ground) prong from the power cord
supplied. For personal safety, this appliance must
be properly grounded. Any questions concerning
power and/or grounding should be directed
toward a certified electrician or an authorized
service center.
The appliance requires a standard 115/220 Volt
AC-60HZ three-prong grounded electrical outlet.
Have the wall outlet and circuit checked by a
qualified electrician to make sure they outlet is
properly grounded. When a standard 2-prong
wall outlet is encountered, it is your responsibility
and obligation to have it replaced with a properly
grounded 3-prong wall outlet.
To prevent accidental injury, the cord should
be secured behind the appliance and not le
exposed dangling.
The appliance should always be plugged into
its own individual electrical outlet which has a
voltage rating that matches the rating label on
the appliance. This provides the best performance
and also prevents overloading house wiring
circuits that could cause a fire hazard from over
heating. Never unplug the appliance by puling
on the power cord, always grip the plug firmly
and pull straight out from the receptacle. Repair
or replace immediately all power cords that have
become frayed or otherwise damaged. Do not
use a cord that shows cracks or abrasion damage
along its length or at either end. When moving
the appliance, be careful not to damage the
power cord.
Because of potential safety hazards under certain
conditions, it is strongly recommended that you
do not use an extension cord with this appliance.
However, if you must use an extension cord it is
absolutely necessary that it be a UL/CUL-Listed,
3-wire grounding type appliance extension cord
having a ground type plug and outlet and that
the electrical rating of the cord be 115 volts and at
least 1.3 amperes.
ELECTRICAL CONNECTION CONTINUED EXTENSION CORD
INSTALLATION
This appliance includes a stainless-steel handle
that is not required to operate this unit. To install
the handle please follow the below instructions:
1. Pull away the door gasket in the area where
the handle is to be installed as shown in
illustration. The gasket is easily displaced by
hand, no tools are necessary.
2. Locate the screws included in the bag with
the user’s guide. Insert the screws into the
holes as shown.
3. Align the handle with the screws installed.
Tighten the screws using a Phillips head
screwdriver until the handle sets both flush
and secured tightly against the door frame.
(DO NOT over tighten as this will cause
damage to the handle assembly).
4. Replace the door gasket to its original
Position.
INSTALLING THE STAINLESS STEEL HANDLE
Loading ...
Loading ...