Loading ...
Loading ...
Loading ...
3
Put the screws on top of the drawer where the
handle is to be installed. Align the handle with
screws, tighten the screws using the screwdrivers.
ELECTRICAL CONNECTION
Improper use of the grounded plug can
result in the risk of electrical shock. If the
power record is cord is damaged, have it
replaced by a qualified or an authorized
service dealer.
WARNING!
OPERATING YOUR APPLIANCE
Remove the exterior and interior packing.
Before connecting the appliance to the power
source, let it stand upright for approximately
24 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water
using a so cloth.
Install the handle on the drawer if not already
aached.
The Kegerator is able to maintain the proper
dispensing temperature for beer, provided it is
installed correctly in the proper environment. For
best results, mount the dra tower as close to
the top of the kegerator as possible and seal any
openings to prevent heat transfer. Avoid opening
and closing the door of the kegerator too oen
to ensure a consistent temperature inside the
unit. Factory preset temperature is 36 degrees
Fahrenheit.
The Kegerator should be placed in an area where
the ambient temperature range is between 50-
109.4 degrees Fahrenheit (10-43 degrees Celsius).
If the ambient temperature is above or below
this range, the performance of the unit may
be affected. For example, placing your unit in
extreme cold or hot conditions may cause interior
temperatures to fluctuate. Please be aware
that the desired temperatures may fluctuate
depending on the ambient temperature and the
orientation of the keg.
Press first, then press or buon
to increase (warm) or decrease (cool) the set
temperature by 1°C/ 1°F.
Press again, the temperature is selected and
shows the actual temperature. If no other further
operation in 6 seconds, display will show actual
temperature in the cooler
The temperature you are seing will increase by
one degree each time you press the key and
will decrease by one degree each time you press
the key.
The range of temperature control is from 32°F
to 50°F.
To view the set temperature at any time, press
the key. The set temperature will flash in the
display window for 6 seconds. Aer 6 seconds,
the temperature inside the until will reappear in
the display window.
(The temperature preset at the factory is 36°F)
CONTROL PANEL
°F/°C SELECTOR
SETTING THE TEMPERATURE CONTROL
BEFORE USING YOUR APPLIANCE
OPERATION INSTRUCTION
ON/OFF Power
To turn the appliance ON or OFF, press and hold
the POWER key for 5 seconds.
UP and DOWN
SET
SET
Selects the temperature display seing in
Fahrenheit or Celsius degrees. To change the
temperature from Fahrenheit to Celsius or from
Celsius to Fahrenheit, press and at the
same time, then hold for 6 seconds.
SET
SET
Loading ...
Loading ...
Loading ...