Loading ...
Loading ...
Loading ...
Specication
Mower Blade Bolt—Torque. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . 68 N·m (50 lb·ft)
MX52301,0000F09-19-28MAR16
Service Electrical
Electrical
WARNING:Avoid injury! Battery posts, terminals and related
accessories contain lead and lead components, chemicals known to
the State of California to cause cancer and reproductive harm. Wash
hands after handling.
MP47322,00F466E-19-03MAY20
Service the Battery Safely
MXAL42869—UN—09APR13
CAUTION: Avoid injury! The battery produces a ammable
and explosive gas.
To prevent the battery from exploding:
● Do not smoke or have open ame near battery.
● Wear eye protection and gloves.
● Do not allow direct metal contact across battery posts.
● Remove negative cable rst when disconnecting.
● Install negative cable last when connecting.
MP47322,00F466F-19-13JAN15
Removing and Installing the Battery
Removing
1. Park machine safely. (See Parking Safely in the Safety section.)
2. Rotate operator seat forward.
3. Remove battery compartment cover.
GX536017—UN—26APR22
4. Disconnect negative (-) battery cable (A).
5. Push red cover (B) away from positive (+) battery terminal and
remove cable (C) from battery.
6. Remove strap (D).
7. Remove battery.
Installing
1. Place battery into the battery tray as shown.
2. Put battery strap.
3. Connect positive (+) cable to battery rst, then negative (-) cable.
4. Apply general-purpose grease or silicone spray to terminals to help
prevent corrosion.
5. Slide red cover over the positive battery terminal.
6. Install battery compartment cover.
7. Lower operator seat.
H9PQBYK,0000050-19-21APR22
Cleaning Battery and Terminals
1. Park machine safely. (See Parking Safely in the Safety section.)
2. Disconnect and remove battery.
3. Wash battery with solution of four tablespoons of baking soda to
one gallon of water. Be careful not to get the soda solution into the
cells.
4. Rinse the battery with plain water and dry.
5. Clean terminals and battery cable ends with wire brush until bright.
6. Install battery.
7. Attach cables to battery terminals, beginning with the positive
cable, using washers and nuts.
8. Apply general purpose grease or silicone spray to terminals to help
prevent corrosion.
MG39705,00000D8-19-13JUN22
Using Booster Battery
CAUTION: Avoid injury! The battery produces a ammable
and explosive gas.
To prevent the battery from exploding:
● Do not smoke or have open ame near battery.
● Wear eye protection and gloves.
● Do not jump-start or charge a frozen battery. Warm
battery to:
Service Electrical
45
Loading ...
Loading ...
Loading ...