Loading ...
Loading ...
Loading ...
20 21
14 - Replace the pilot ame nozzle
Using a suitable screwdriver, unscrew the pilot
ame nozzle (L) and replace it with the new
nozzle.
15 - Resetting the pilot ame
Reposition the pilot ame head as shown in
the enlarged photo. Check that the T created
by the openings respects the indicated
position.
16 - Let’s restore the pilot group
At this point restore the pilot assembly by
repositioning the block (G) previously removed.
Then proceed in reverse from point 7 to point 2
of the previous page.
12 - Remove the pilot ame
Once the stop (G) has been removed, remove
the pilot ame head (H).
13 - We reach the nozzle
We raise the pilot ame and unscrew the cap
to reach the pilot ame nozzle (L).
G
H
L
F1
F2
OVEN
A
E
LPG/NG CONNECTION AND INSTALLATION
ONLY FOR GAS VERSION
INSTRUCTIONS FOR NORTH AMERICA ONLY
LPG CONNECTION
A REGULATOR CONNECT TO OVEN (supplied)
E 1/2” MALE GAS FITTING (3/8” OD FLARE X 1/2”
MIP - TAPPED 3/8” FIP (supplied)
F1 LPG HOSE CONNECT TO OVEN (supplied)
F2 LPG HOSE/REGULATOR CONNECT TO PROPANE
GAS CYLINDER. (supplied)
• Connect Regulator (A) to the oven.
• Connect Propane Hose (F1) to the Regulator (A)
using 1/2” Male Gas
• Fitting (E) - 3/8” OD Flare x 1/2” MIP - Tapped 3/8” FIP.
• Connect Propane Hose/Regulator to Propane Gas
Cylinder
*Use PTFE tape or pipe thread sealant where needed
LPG / NG REGULATOR CONVERSION INSTRUCTIONS
1 2 3
4 5
LPG
NATURAL
GAS
H G
A
1 - BEGIN BY CONVERTING
THE REGULATOR FROM LPG
TO NG (H)
2 - UN SCREW THE CAP TO
ACCESS THE REGULATOR
ADJUSTMENT.
3 - THE PLASTIC ADAPTER
SHOULD BE TURNED UPSIDE
DOWN DEPENDING ON THE
TYPE OF GAS SUPPLY.
4 - CONVERTING THE REGULATOR 5 - REFIT THE CAP.
CONVERSION LPG-NG NEEDLE
ONLY FOR GAS VERSION
INSTRUCTIONS FOR NORTH AMERICA ONLY
11 - Pilot group release
Remove the block (G) of the pilot group to
proceed with the adjustment of the pilot ame.
Just unscrew the two screws circled in red.
G
Loading ...
Loading ...
Loading ...