Loading ...
Loading ...
Loading ...
16 17
1 - Connect to 20lb. tank using supplied regulator hose or direct connect
to natural gas source. Make sure the burner stabilizer is connected in the
correct direction to the burner at the oven.
2 - Push IN the burner knob and turn it counter-clockwise to the star
symbol on the control panel.
3 - While KEEPING the burner knob pushed in, push the ignition
button at the same time to light the burner pilot ame.
NOTE: Lighting the pilot ame for the rst time or after it has cooled
could take some time and possibly a few attempts due to air in the
supply line. Be patient as the gas makes its way to the pilot light.
4 - Once the pilot ame is lit properly you will see a small ame
inside (rear left corner) of the oven. You can now release the ignition
button BUT will need to KEEP the burner knob pushed in for 15 seconds.
This will ensure that the thermocouple is hot enough to allow the pilot
ame to stay on.
5 - Slowly release the burner knob and turn it counter- clockwise to
the larger dual ame symbol on the control panel.
The oven burner is now on high and you can start preheating the oven.
Wind can cause the ame to blow out depending how low the setting is.
6 - Return oven door to warming shelf leaving 1-2” gap all the way
around the oven opening so air can enter the oven. Do replace oven
door tightly or the lack of air will force the ame to extinguish. Preheat
oven for 45 minutes to allow the re bricks to get to pizza making temp.
Using a laser thermometer, check the oven oor temperature. You want
the oor to be 370°- 430°C (700°- 800°F) to make pizza.
LIGHTING THE OVEN
ONLY FOR GAS VERSION
INSTRUCTIONS FOR NORTH AMERICA ONLY
WARNING: Follow the instructions before turning on the oven.
• Check all gas connections for gas leak before starting your oven.
• Use the proper PTFE gas piping tape for all threaded connections
• Do not lean over the oven when lighting. Keep your face and body
at a safe distance from the oven door.
• When lighting the oven, the oven door must be open.
• The burner control knob must be in the o position before turning
on the LGP cylinder valve.
• Do not move the oven while it is in use.
1a 1b
2 4
1c
5
FOR YOUR SAFETY:
• Do not exceed the temperature limit of 500°C / 950°F.
• Never disconnect the gas pipe or other ttings when using the oven.
PUSH
3
Continue next page >>>Continue next page >>>
Loading ...
Loading ...
Loading ...