Loading ...
Loading ...
Loading ...
C6647M (10/21) 17
Connecting the Cables
Refer to the table in the All-in-One Cable Section to identify all I/O interfaces. The All-in-One Cable is also labeled with this information. Make
the appropriate/applicable cable connections.
ETHERNET WIRING REQUIREMENT FOR POE+
Connect a Cat5e cable or higher cable (not supplied) to the RJ-45 network connector. The 8-pin port includes video over Ethernet, and PoE+ for
the cam
era. PoE+ injects power over the same cabling that carries the network data, eliminating the need for a separate power supply. This
simplifies the installation and operation of the camera without affecting network performance.
POWER WIRING
To wire the connector, insert cables into the power connector (supplied). Attach the cables as identified in the All-in-One Cable Section (e.g. Pin
1 is +12 VCD o
r 24 VAC 1; Pin 2 is -12 VDC or 24 VAC 2) with a small slotted screwdriver and then plug the connector into the All-in-One Cable
Plug.
NOTES:
• 12 VDC or 24 VAC may be used instead of PoE+ or in addition to PoE+ for power failover in case PoE+/network is temporarily lost.
• Power failover is only supported when the camera is connected to a dedicated auxiliary power supply, 12 VDC/24 VAC. No other came
ras
can be connected to this auxiliary power supply. It is OK for the camera to share PoE from a switch that has other cameras connected to it.
1000BASE-TX
Pin Function
1 BI_DA+
2 BI_DA-
3 BI_DB+
4 BI_DC+
5 BI_DC-
6 BI_DB-
7 BI_DD+
8 BI_DD-
Loading ...
Loading ...
Loading ...