Loading ...
Loading ...
Loading ...
C6647M (10/21) 15
Surface Mount with Wall Mount Junction Box (IBP3BBAP-ES)
PARTS LIST SUPPLIED WITH THE MOUNT
Figure 4. Installation with Wall Mount Junction Box
INSTALLATION GUIDE
1. Attach the IBP3BBAP-ES backbox (#1) to the desired surface:
a. Using the Mounting Template, mark the position of the three mounting hole locations to be used as well as the cable entry position if
cables will enter through the back of the jun
ction box.
b. Using a 1/4” drill bit, drill the mounting holes (and if applicable, the cable entry hole with a 1” to 1-1/2” drill bit).
c. Press in the plastic anchors (supplied) into the holes.
d. Incoming cables should be fed through the backbox from the back or side depending on your installation.
e. Secure the backbox to the wall by attaching it to the wall using the two M4 x 31 mm screws (supplied).
2. Attach the Bullet Mounting Base to the cover plate:
a. Feed the All-in-One cable through the center opening of the cover
plate.
a. Secure the Bullet Mounting Based to the cover plate using the 4, M4 x 14 mm Tamper Resistant Screws.
3. Slip the rubber grommet onto the All-in-One cable, and then insert the rubber grommet into the center hole of cover plate (#2).
NOTE: Please identify both sides of the rubber grommet. The angled side must be facing towards the terminals of the cables and cover plate to
prevent water ingres
s.
4. Secure the rubber grommet to the cover plate by attaching the metal plate (supplied) to the cover plate with 3, M3 x 8 mm screws.
5. Refer to the Connecting the Cables section before proceeding.
6. Attach the cover plate (#2) to the backbox with the 3, M4 x 10 mm screws (supplied).
7. Proceed to the Positioning the Camera section to complete the installation.
Qty Description
1 Wall mount junction box
1 Mo
unting Template
4 Plastic screw anchors
4 M4 x 31 mm self-tapping screws
4 M4 x 14 mm T20 tamper resistant screws
3 M4 x 10 mm Phillips screws
3 M3 x 8 mm Phillips screws
1 Metal plate
1 Waterproof rubber grommet
Loading ...
Loading ...
Loading ...