Loading ...
Loading ...
Loading ...
8
<Image of safety wire connection>
Note:
When the existing anchor bolt that has been •
installed is used for connecting the safety
wire, the use of 2 spacer nuts is helpful.
Spacer nuts
Safety wire
Safety wire angle
Spacer nuts
Existing anchor bolt
Step 3
Secure the safety wire angle (accessory) to the
anchor bolt (for connecting the safety wire),
and connect the safety wire (accessory).
Mount a nut so that the safety wire angle is q
secured on the anchor bolt.
Disconnect the safety wire from the safety w
wire angle.
Engage the face marked e q with the anchor
bolt.
Bend the face marked r w.
Connect the safety wire to the safety wire t
angle again.
Engage the nut from beneath, and secure y
the safety wire angle with top and bottom
nuts.
Engage another nut from beneath to tighten u
and secure the nut that was engaged from
beneath in y in a double nut fashion.
IMPORTANT:
The pull-out strength of the anchor bolt shall be more than 5 times of the total weight of the •
installed devices (including the camera body, ceiling mount bracket, anchor bolts, and all other
parts).
When the existing anchor bolt is used as an anchor bolt for connecting the safety wire, make •
sure that the distance between the anchor bolt and camera mounting position is 1 m {3.28 feet}
or less.
Upper side
Lower
side
Safety wire
e Insert
w Disconnect
r Bend
Mark w
Mark q
t Connect
Safety wire angle
Anchor bolt
* The nut is omitted in the illustration above.
Loading ...
Loading ...
Loading ...