Loading ...
Loading ...
Loading ...
Note
The PTZ control is automacally locked to avoid interrupon during conguraon.
2.
Set vericaon points.
1) Adjust the pan, lt, and zoom to nd the scene with a vericaon point.
2) Click and click on the vericaon point on the live image.
The selected point is zoomed in and placed in the center of the image.
3) Click again.
A red cross shows on the point.
4) Click Add and input the precise longitude and latude of the point.
Note
You must add at least 4 points, otherwise you cannot save the points.
5) Click Save.
6) Repeat the steps to set other vericaon points.
Numbered green and blue rectangles are displayed on the image. The blue rectangle marks
the PTZ posion of the vericaon point you set and the green rectangle marks the calculated
PTZ posion based on the longitude and latude you input. If the two rectangles are close to
each other, then the GPS calibraon succeeds.
4.15 Set Device Posion
Before You Start
Go to Conguraon → PTZ → Basic Sengs → PTZ OSD to enable PT Status display.
Steps
1.
Go to Conguraon → System → System Sengs → Locaon .
2.
Select a PT Mode.
Manual Use a direcon indicang device to determine the North at the device locaon, and
set the North for the device. For details, see
Set Manual Compass .
3.
Click Calibrate to calibrate gyroscope atude.
Note
Only devices with built-in gyroscope support this funcon.
4.
Select a Longitude-Latude Mode to set the geographic locaon of the device.
Auto For device with a built-in posioning module, select Auto to automacally obtain
the longitude and latude of the device locaon.
Manual Get the device locaon informaon in advance, and input the longitude and
latude manually.
5.
Click Save.
TandemVu PTZ Camera User Manual
28
Loading ...
Loading ...
Loading ...