Loading ...
Loading ...
Loading ...
C6659M (10/21) 13
ETHERNET WIRING REQUIREMENT FOR POE
Connect a Cat5e cable or higher cable (not supplied) to the RJ-45 network connector. The 8-pin port includes
video over Ethernet, and PoE for the camera. PoE injects power over the same cabling that carries the
network data, eliminating the need for a separate power supply. This simplifies the installation and
operation of the camera without affec
ting network performance.
Figure 6. Pin Numbering
Figure 7. Pin Functions
POWER WIRING
To wire the connector, use a small slotted screw driver to depress the connector tabs and then insert cables
into the power connector. Attach the cables as shown in Figure 1 (e.g. Pin 1 is 12 VDC or 24 VAC 1; Pin 2 is
GND or 24 VAC 2).
NOTES:
• 12 VDC or 24 VAC may be used instead of PoE or in addition to PoE for power
failover in case PoE/
network is temporarily lost.
• Power failover is only supported when the camera is connected to a dedicated auxiliary power supply, 12
VDC/24 VAC. No other cameras can be connected to this auxiliary power supply. It is OK for the camera
to share PoE from a switch that has other cameras connected to it.
1000BASE-TX
Pin Function
1 BI_DA+
2 BI_DA-
3 BI_DB+
4 BI_DC+
5 BI_DC-
6 BI_DB-
7 BI_DD+
8 BI_DD
-
Loading ...
Loading ...
Loading ...