Loading ...
Loading ...
Loading ...
GENERATOR OPERATION
Operating Location
• Only use OUTSIDE and place the generating set in a well-ventilated area.
• Only operate the generating set on a flat, level surface and in a clean, dry
operating environment.
• Allow two feet clearance on all side of the generating set while operating it
outdoors.
• Operate in specified area, if any problem on applicable occasion, please
consult the authorized local dealers. In some areas, generating set must be
registered with the local utility. Genera
ting set used to construction sites may
be subject to additional rules and regulations.
Start The Generator
1. Unplug all electrical loads from the unit's receptacles before starting engine.
2. Place generator on a level surface.
3. Open the fuel shut-off valve to ON position.
4. Turn engine ON/OFF switch to ON.
5. Slide engine choke to Full CHOKE position (left).
6. Firmly grasp recoil handle and pull slowly until increased resistance is felt. Pull
rapidly up and away.
7. When engine s
tarts, move choke knob to 1/2 CHOKE position until engine runs
s
moothly, then fully into RUN position. If engine falters, move choke back to
1/2CHOKE position until engine runs smoothly, then to RUN position.
NOTE: If engine fires, but does not continue to run, move choke lever to Full
CHOKE and repeat starting instructions.
1
2
3
ON
4
ON
5
6
7
16
Loading ...
Loading ...
Loading ...