Loading ...
Loading ...
Loading ...
Keypad Possible faults Possible action
Error LED flashes The handle is not fully expanded
and locked in the operation posi-
tion.
Fully extend the handle and lock it in the op-
eration position. Refer to
To set the product
in operation position on page 13
. After this
step, push the ON/OFF button to make the
error LED go out.
Low battery power. Charge the battery. Refer to
To charge the
battery on page 13
. After this step, push the
ON/OFF button to make the error LED go
out.
There is overload in the motor. Increase the cutting height. Refer to
To set
the cutting height on page 13
. After this
step, push the ON/OFF button to make the
error LED go out.
Remove grass blockage around the blade.
Remove the battery and manually remove
the grass.
Battery error or no signal from
the battery.
Put the battery in the product correctly. Re-
fer to
To start the product on page 15
. After
this step, push the ON/OFF button to make
the error LED go out.
Replace the battery. Refer to
To start the
product on page 15
. After this step, push
the ON/OFF button to make the error LED
go out.
Error LED stays on Servicing or repair of the product
is necessary.
Stop the product immediately and speak to
your Husqvarna service agent.
High temperature in-
dicator
The motor control is too hot. Stop the motor and wait until it has become
cool.
The product stops The battery is weak. Charge the battery. Refer to
To charge the
battery on page 13
.
The battery connector failure. Examine the battery connector.
Transportation, storage and disposal
Introduction
WARNING: To prevent accidental
start during transport, remove the
battery and wait a minimum of 5
seconds.
To set the product in transport position
1. Remove the grass catcher (if installed).
1840 - 005 - 11.07.2023
23
Loading ...
Loading ...
Loading ...