Loading ...
Loading ...
Loading ...
106
PROBLEM SOLUTION
The wrong TV channel
was decoded (entered)
after you programmed
a recording using
VIDEO Plus+ System.
bThe programme number of the TV channel is not available in the GUIDE Plus+
®
system or
allocation is wrong.
To change or check the channel data, proceed as follows:
1 Press GUIDE/TV .
2 Press P+ A .
3 Select 'Editor' with C .
4 Select the TV channel using P- B or P+ A .
5 Press C to go to the right tile.
In case you can receive the selected channel only via an external receiver, press the red
button to select the corresponding source.
6 Press the green button.
7 Enter the programme number of the TV channel using the number buttons.
If the source you have selected is an external receiver, enter the programme number that
you would also enter at the external receiver for this TV channel.
8 Confirm with OK .
There is no channel
overview in the GUIDE
Plus+
®
system
bDVD recorder is switched on: Switch off the DVD recorder to allow data transfer
bThe TV channel that transmits the GUIDE Plus+
®
data is not set properly.
bExternal receiver (satellite receiver, set-top box, cable TV box, ...) (if available) is switched off:
switch on the external receiver
bG-LINK cable is not connected: Connect the G-LINK cable and make the necessary settings to
control the external receiver (see chapter 'The GUIDE Plus+
®
system', section 'Installation of the
'External receiver 1'').
Missing or wrong TV
channel in the 'Grid'
screen
bWrong local post code/country was entered
bPlease check your correct channel line up in the 'Grid' screen.
Read therefore the section 'The 'Editor' screen.
When you press
GUIDE/TV the GUIDE
Plus+
®
setup screen will
appear
bThe GUIDE Plus+
®
system was not completely installed or local post code was not entered.
1 Check the settings
2 Select the corresponding line using P- B or P+ A and confirm with OK .
3 For more information on the individual functions, see chapter 'The GUIDE Plus+
®
system',
section 'Installation of the 'External receiver 1''.
The external receiver
does not always react
to Remote control
signal.
bThe Infrared (IR) Remote control signal interfere with the IR signal of the G-LINK transmitter.
Put the G-LINK transmitter closer to the front of the external receiver.
My external receiver
switches automatically
through the TV
channels
bIf the DVD-Recorder is switched off ( STANDBY m button) the external receiver will be used
from the GUIDE Plus+
®
system via the DVD-Recorder. If you want to watch TV-Channels from
the external receiver, you have to switch the DVD-Recorder on.
There is picture or
sound interference on
TV reception:
bBefore recording, select the recording mode as described in chapter 'Manual Recording', section
'Selecting the recording mode (quality)'.
bHave your aerial checked.
bYou will find information on how to change the TV system in 'Manual TV channel search' in
'Installing your DVD recorder'.
Before you call an engineer
Loading ...
Loading ...
Loading ...