Loading ...
Loading ...
Loading ...
Product Care
4
14
Maintenance Schedule
Before
Each use
Every
10 Hours
Every
25 Hours
Every
50 Hours
Every
100 Hours
Prior
to Storing
Check/Clean Engine Intake Screens & Cooling Fans *
P P
Check/Clean Exhaust Manifold, Muer Pipe & Muer
Shields *
P P
Check/Clean Hood/Dash Panel Louvers *
P P
Check/Clean Top & Underside of Deck, Under and Around
Spindle Covers & Belt Area *
P P
Check/Clean Around Fuses, Wiring and Wiring Harnesses *
P P
Check/Clean Around Transmission, Axle and Fans *
P P
Clean Hood/Dash Louvers
P P
Clean Battery Terminals
P P
Lube Front Axles and Rims
P P
Clean Engine Cooling Fins
P P
Lube Pedal Pivot Points
P P
*-- Perform more often in dry conditions and/or when mulching
Important: It is important to consult the specific Engine Operator’s Manual included with this machine for detailed engine maintenance procedures and intervals.
WARNING
Before inspecting or cleaning always disengage the PTO, set the
parking brake, stop the engine and remove the key to prevent
unintended starting.
Troubleshooting
Excessive Vibration
1. Cutting blade loose.
• Tighten cutting blade and deck spindle.
2. Cutting blade damaged, unbalanced or bent.
• Replace the cutting blade.
Uneven Cut
1. Deck not properly leveled.
• Perform side-to-side deck adjustment.
2. Cutting blade dull or damaged.
• Sharpen or replace cutting blade.
3. Uneven tire pressure.
• Check and correct tire pressure in all
four tires.
2. Disengage the PTO, set the parking brake and
stop the engine.
3. Thread the hose coupler (packaged with your
rider’s Operator’s Manual) onto the end of your
garden hose.
4. Attach the hose coupler to the water port on
your decks surface. See Figure 4-1.
Figure 4-1
Note: Make sure that the hose is not routed under
the deck and is clear of all moving parts.
5. Turn the water on.
6. While sitting in the operator’s position on the
rider, start the engine and place the throttle
lever in the FAST
position.
7. Move the rider’s PTO into the engaged (ON)
position.
8. Remain in the operator’s position with the
Post-Operation Rider Care
After each operation of the rider, the following
procedures should be implemented to extend the life
of your rider and ensure safe operating conditions.
DANGER
Failure to follow these recommendations may result in serious
injury to yourself or others and may cause damage to the rider.
Cleaning the Underside of the Deck
Smart Jet
Your rider’s deck is equipped with a water port on its
surface as part of its deck wash system.
Use the Smart Jet to rinse grass clippings from the
deck’s underside and prevent the buildup of corrosive
chemicals. Complete the following steps AFTER EACH
MOWING:
1. Drive the rider to a level, clear spot on your
lawn, near enough for your garden hose to
reach.
WARNING
Make certain the rider’s discharge chute is directed AWAY from
people, your house, garage, parked cars, etc.
Loading ...
Loading ...
Loading ...