1. Home
  2. Ancona
  3. Ancona AN-1328 User Manual
  4. Page 16

Ancona AN-1328 Pro 46″ 600 CFM Ducted Insert Range Hood

User Manual and Installation Instructions - Page 16

For AN-1328.

PDF File Manual, 20 pages, Read Online | Download pdf file

AN-1328 photo
Loading ...
Loading ...
Loading ...
— 16 —
Maintenance
u
Make sure the range hood is unplugged or turn OFF
breaker.
v
Remove lters. Reach into interior of range hood
until touching both lateral clips located on the side
ofthepucklight.Gentlysqueezeandpushdown
until puck pops out from its location, pull out the
LED puck and unplug it.
CAUTION: PUCK MAY BE HOT, PLEASE TAKE
OUT THE PUCK WHEN THE PUCK IS
COMPLETELY COOL!
w
Replace with a 12 Volt, 1.5 Watt max, LED lights.
Plug in new puck and push back into light panel.
x
Turn ON breaker and range hood to test for
operation.
Replacing the Light Pucks
IMPORTANT:
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY AT THE MAIN PANEL BEFORE CARRYING OUT ANY OPERATION
ON THE APPLIANCE.
Problem Possible Cause
If the range hood or LED light does
not operate after installation:
Check if the range hood has been plugged in, make sure that
all power has been turned back ON, fused not blown and all
electrical wiring are properly connected.
The range hood vibrates when the
blower is on:
The range hood might not have been secured properly on to the
ceiling or wall.
The blower or fan seems weak: Checkthattheductsizedusedisatleast6in.(15.3cm)or3
1/4 × 10 in. (8.3 × 25.4 cm). Range hood WILL NOT function
efcientlywithinsufcientductsize.Forexample:7in.(17.7cm)
duct over 6 in. (15.3 cm) hole and loosely secured.
Checkifductiscloggedorifdamperunit(half-circularange)is
not installed correctly or opening properly. A tight mesh on a side
wallcapunitmightalsocauserestrictiontotheairow.
The lights work but the fan is
not spinning at all, is stuck or is
rattling:
The fan might be jammed or scraping the bottom due to
shipping damage. Please contact us immediately.
Make sure the distance between the stove top and the bottom of
the hood is within 24 in. and 30 in. (61 and 76.2 cm) in distance.
The hood is not venting out
properly:
Reduce the number of elbows and length of duct work. Check if
all joints are properly connected, sealed, and taped.
Troubleshooting
Figure 14 Figure 15
Loading ...
Loading ...
Loading ...