Ancona AN-1328 User Manual and Installation Instructions

Loading ...

— 13 —

STEP 11

Connect Ductwork

• Attach ductwork to damper. Secure the ductwork with duct tape to

make sure joints are secure and air- tight.

• Do not install the duct tape too tightly as this may prevent the

damperapsfromopeningwhichwilloverworkthemotorandcause

improper functioning of the unit.

• Fasten all connections with sheet metal screws and tape all joints

with certied aluminum or foil tape. Use caulking to seal exterior

wall or roof opening around the cap.

• For additional support, use pre-drilled holes and mounting screws to attach side and top of the range hood (see Figure

8 and 9).

Figure 10

Figure 8 Figure 9

STEP 12

Connect to AC

• ConnectACplugintoagroundedACoutlethaving120V,60Hz.Placetheoutletatamaximumdistanceof33-1/2in.

(851 mm) from where the cord exits on the hood.

• SEE IMPORTANT INSTRUCTIONS ON NEXT PAGE.

3-Pronged Plug

Ground Plug

3-Prong Receptacle

Installation

Loading ...

Ancona AN-1328 Pro 46″ 600 CFM Ducted Insert Range Hood