Loading ...
Loading ...
Loading ...
4
SAFETY WARNINGS AND PRECAUTIONS
PLEASE READ AND UNDERSTAND THE FOLLOWING SAFETY HIGHLIGHTS.
BE SURE THAT ALL INSTALLATION, OPERATION, MAINTENANCE AND
REPAIR PROCEDURES ARE PERFORMED ONLY BY QUALIFIED INDIVIDUALS. ARC
AND TIG WELDING CAN BE HAZARDOUS. PROTECT YOURSELF AND OTHERS FROM
POSSIBLE SERIOUS INJURY OR DEATH. KEEP CHILDREN AWAY. PACEMAKER
WEARERS SHOULD CONSULT WITH THEIR DOCTOR BEFORE OPERATING.
WHEN USING THE WELDER, ALL BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED TO REDUCE THE RISK OF PERSONAL INJURY AND DAMAGE TO
EQUIPMENT.
DRY WORKING PLACE. DO NOT WELD IN PLACES WITH HIGH HUMIDITY.
FOR THE POWER EXTENSION CORD, PLEASE MAKE SURE THE WIRE GAUGE IS MORE
THAN 11 GAUGE AT 220VAC AND 13 GAUGE AT 110VAC. USING A NON-METALLIC
CHAIR PLACED ON A RUBBER MAT WHILE WELDING IS RECOMMENDED. USE 20 AMPS
CIRCUIT BREAKER FOR 110VAC AND 30 AMPS CIRCUIT BREAKER FOR 220VAC. DO NOT
USE TRIPLE PHASE, INSTEAD USE SINGLE PHASE POWER.
READ ALL INSTRUCTIONS BEFORE USING THIS WELDER.
Keep work area clean. Cluttered areas invite injuries.
Observe work area conditions. Do not use machines or power tools in damp or wet locations.
Do not expose to rain. Keep work area well-lighted. Do not use electrically powered tools in the
presence of flammable gases or liquids.
Keep children away. Children must be never be allowed in the work area. Do not let them
handle machines, tools or extension cords.
Store idol equipment. When not in use, tools must be stored in a dry location to inhibit rust.
Always lock up tools and keep them out of the reach of children.
Do not force tool. It will do the job better and safer at the rate for which it was intended. Do not
use inappropriate attachments in an attempt to exceed the tool capacity.
Use the right tool for the job. Do not attempt to force a small tool or attachment to do the work
of a larger industrial tool. There are certain applications for which this welder was designed. Do not
modify this welder and do not use this welder for any other purposes for which it was not intended.
Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts.
Protective, flame retardant, electrically non-conductive clothing and non-skid footwear are
recommended when working. Wear restrictive hair covering to contain long hair.
Use eye and ear protection. Always wear ANSI approved, arc shaded, impact safety face shield
(welding helmet). Always use a full-face shield when welding. Always wear ANSI approved eyewear
under face shield and while in the workplace. Wear a NIOSH approved dust mask or respirator when
working around metal, chemical dusts, fumes and mists.
Do not over reach. Keep proper footing and balance at all times. Do not reach over or across
running machines.
Loading ...
Loading ...
Loading ...