WH6000 Owner's Manual

Loading ...

Starting an Electric Start Generator

Verify the battery is properly installed and both

battery cables are attached (see Installing the

Battery (Electric Start Generators Only) on page

18).

2. Make sure the circuit breakers are properly set (see

Figure 26).

Move the choke lever to the ON position (see

Figure 28).

Figure 26 - Circuit Breakers

1 - 240/120V Main 3 - 120V Circuit

Circuit Breaker Breaker

Operating Operating

Position Position

2 - 240/120V Main

Circuit Breaker

Tripped Position

4 - 120V Circuit

Breaker Tripped

Position

Move the fuel shutoff valve to the ON position (see

Figure 27).

Figure 27- Fuel Shutoff Valve in the ON Position

Figure 28 - Choke Lever

Push and hold the engine control switch in the

START position until the engine starts. Once the

engine starts, release the engine control switch; the

switch will automatically move into the RUN position

(see Figure 29).

Figure 29 - Engine Control Switch

Failure to release the engine control switch once

the engine starts could result in damage to the

generator,

Never push the engine control switch to the START

position while the engine is running; this could

damage the generator,

WESTPRO

POWER SYSTEMS

Loading ...

Owner's Manual - Page 26