Loading ...
Loading ...
Loading ...
D. LI1NE REPLACEMENT
e For proper Hne feed:
- Use only genuine pre-wound spools or
.080" dia. replacement line. Use of other
typesofspoolsor linescanresult in excessive
breakage,linewelding,andimproperRue feed.
- Pre-wound spoolsofferthe most conven-
ientmethod for replacing line as we]] as
opthnum perfermance.
• Always clean dirt and debris from the spool
and hub when performing any type mainte-
I1B2RCe.
I . f
Trimmer head ]parts that are chipped, cracked, [
lbroken, or damaged in .any other way can fly]
[apart and cause serious injury. Do not use. Re-[
[place damaged parts before using the unit. I
The Rue limiter (on the underside o£
the shield) is sharp and cancutyou.
L Installing Spool with Line
a. Step the unit and unplug the power cord.
b. Push the Release Button and Iift off the T]_Jn-
mer Head Cover. Figure 9.
c_ Remove the spool. Figure 10.
d. Clean dir_and debris from allparts. Inspect ell
Trimmer head par_s for damage. Replace dem-
ag_ parts.
e. Replace er rewind old spool.
£ Align the Slot in the spool with the Key in the
Hub. Figure 10. Set the spool into the Hub.
Allow 3 te 4inches of line to extend through the
line exit epening. Figure 10.
go Reinstall the Trimmer Head Cover. _ 9.
Make surethetabsareinplaceand s_n-ely
fastened.
_. Installing Line On Spool
w Holdspoolasshown inFigureII.
b. Insert 1/4 to 3/8 inch ef line through the ta-
pered slotinthespool._gure 11(inset).
c. Wrap lineevenlyinthedirectionindicatedby
• - the arrow on the spool, To ensure proper line
advance,avoidcrossoveror crisscrossing the
llne.
NOTE.- Do not wrap more than 25 feet ef
.080 _dia. Laser Line ontu the spool.
_.d._ellow instructions in "rnstallingSpool w/
_Une,"steps "f."through_g._
• ||1 [ I [Hlll[l[ [ [
Wrap Line In
Direction Of
S. Trouble Shooting the Trimmer Head and Line
• Line breaks or does nbt advance prop. ,,
, Release
Button
Figure 9
Spool
Figure11
HHI I H I
Pulls back into head:
Line Exit
\
t
i i i
erIy:
- Improperly wound ontospool.
- Linesizeincorrect.
- Too llttlelineoutsidehead.
- Inferiorline.
- Too little line outside efhead.
• Welds onto spool:
- Line size incorrect.
I I i,i
NOTES
- Crowdlvg line against material being cut.
- Inferiorline.
H.I, im,r.,lHIIL I I I III
- I0-
Loading ...
Loading ...