Loading ...
Loading ...
Loading ...
Using Air Conditioner
NOTE: Ifthe air conditioner isturned off,
wait 3 minutes before restarting. This I
allows pressure inside the compressor to !
equalize. Failure to follow these I
instructions may cause inefficient
operation.
To reduce the risk of fire, electdc shock, or inJury to persons, read the
IMPORTANT SAFETY iNSTRUCTIONS before operating this appliance
To begin operating the air conditioner, follow these steps:
1. Plug in the air conditioner. (To prevent electrical hazards, do not use an
extension cord or an adapter plug.)
2. Set the exhaust vent to the CLOSED position.
3. Set the thermostat to the highest number (coldest or cooler setting).
4. Set the selector control to the highest FAN or COOL setting (see below).
5. Adjust the louvers for comfortable air flow (see Air Directional Louvers).
6. Once the room has cooled, adjust the thermostat to the setting you find most
comfortable.
Review the "Air Conditioner Features" section for other settings.
Air Conditioner Features
OFF ON
ON/OFFGontro!f_memod#s)
FAN COOL
OFF
-o,O:o : w 22o,o,
COOL/FAN Control (some rnodeJs)
FAN COOL
OFF
HI GH
L_W_ LOW
COOL/FAN/HEAT Control Isome models_
The controls featured in this manual are representational of the many models
available. Your model may offer slightly different features.
Selector Control
The selector control turnsthe uniton or off and allows a choice ofeither cooling room
air, circulating room air at the existing temperature, or heating room air (some
models).
COOL/FAN
Operate COOL/FAN models according to the following suggestions:
• ON/OFF or OFF = Turns air conditioner on and off,
• HIGH COOL = Maximum cooling speed. Begin operation of the air conditioner in
this mode.
• MEDIUM COOL (some models) = Fan runs slower for moderate cooling speeds.
• LOW COOL = Fan runs stow for quiet operation when maximum cooling is not
needed.
• HIGH FAN = Maximum air circulation without cooling
• MEDIUM FAN (some models) = Moderate air circulation without cooling.
• LOW FAN -- Slow air circulatioa without cooling.
HEAT (some models)
The HEATselection provides quiet, efficient circulation of warm air. Turn the selector
to the HEAT setting and set the thermostat at number 1, or lowest setting. When the
HEATsetting is selected, the thermostat maintains the temperature by automatically
turning the heater on and off in response to room temperature. The fan runs
continuously to circulate air in the room.
Once the room is warm, adjust the thermostat to a higher number. Higher numbers
provide less heat, or cooler temperatures.
A slight heat odor may come from the unit when first switching to HEAT after the
cooling season is over. This odor, caused by fine dust particles on the heater, will
disappear quickly.
Loading ...
Loading ...
Loading ...