Loading ...
Loading ...
Loading ...
1
2
3
4
5
6
8
7
3
7 8 95 6
1
4
2
www.PyleUSA.com
6
LINE
Each mono input also features a balanced line input on a 1/4" connector. Unbalanced devices (mono jacks)
can also be connected to these inputs.
• Please remember that you can only use either the microphone or the line input of a channel at any one
time. You can never use both simultaneously!
GAIN
Use the GAIN control to adjust the input gain. This control should always be turned fully counterclockwise
whenever you connect or disconnect a signal source to one of the inputs.
FX
FX sends (or AUX sends) enable you to feed signals via a variable control from one or more channels and
sum these signals to a bus. The bus appears at the console’s FX send output and can be fed from there to an
external eects device. The return from the eects unit is then brought back into the console on the aux
return connectors or normal channel inputs. Each FX send is mono and features up to +15 dB gain.
As the name suggests, the FX sends of the mixing consoles are intended to drive eects devices (reverb,
delay, etc) and are therefore congured post-fader. This means that the mix between dry signal and eect
remains at the level determined by the channel’s aux send, irrespective of the channel fader setting. If this
were not the case, the eects signal of the channel would remain audible even when the level knob is
lowered to -∞.
MAIN CONTROL
1. [PROGRAM] Controller: Select from 16 kinds of internal digital eects,
provides the same signal to L and R stereo.
2. [REPEAT] Echo controller of internal eects: Adjust to achieve the
desired state of internal echo signal.
3. [FX LEVEL] Eects return level controller: Adjust the volume of eect.
4. Level indicators can show the signal level from [STEREO OUT] output.
Adjust the [LEVEL] controller to lower the level if [PEAK] indicator light up
in RED.
5. [LEVEL PHONES] Earphone controller: Adjusts the earphone’s volume.
6. [STEREO LEVEL] Fader: Adjust the overall volume from [STEREO OUT]
output signal.
7. [SEND] Level controller: Adjust the sending level.
8. [RETURN] Level controller: Adjust the return level.
1. USB interface: Use for MP3 input or computer connection
(can be used for U disk or computer software recording)
2. MP3 Display: Displays the status and details of the MP3
play.
3. [MAIN OUT] Output: Connect the active speaker or
amplier.
4. [CTRL OUT] Output: Connect the monitor room to
monitor.
5. [+48V PHANTOM] Button/LED: When the button is
turned ON, the LED light is lit. Turn ON this button when
using the condenser microphone which is phantom
powered.
6. Converting switch for channel 3/4 and USB signal .
Loading ...
Loading ...
Loading ...