Loading ...
Loading ...
Loading ...
EN
20 21
This function can help remove particulate matter from the trap by using
combustion oxidation methods to keep the performance of the trap stable.
This function can match the anti-theft key after replacing the ignition key,
ignition switch, instrument cluster, engine control unit (ECU), body control
module (BCM), and remote control battery.
This function can reset the tire pressure and turn off the tire pressure fault
indicator when the car tire pressure fault indicator light is on.
This function can adjust the vehicle body height sensor for level calibration
after replacing the vehicle height sensor or control module in the air
suspension system, or when the vehicle level is not correct.
This function can initialize the adaptive headlight system. The headlight
system can decide when to turn on the headlights based on the ambient light
intensity. It can also monitor the vehicle’s driving speed, body posture, etc., and
adjust the headlight lighting angle timely.
This function can complete the self-learning of the gearbox and improve the
shift quality when the gearbox is disassembled or repaired which may cause
shifting delay or car impact.
This function can set the sunroof lock off, close in rain, memory function of
sliding/tilting sunroof, outside temperature threshold, etc.
It needs to be performed in the following cases:
•
Replace the exhaust back pressure sensor.
•
Disassembly or replacement of the particle trap.
•
Removal or replacement of fuel additive nozzles.
•
Removal or replacement of catalytic oxidizer.
•
The DPF regeneration fault lamp is lit and matched after maintenance.
•
Repair and replace the DPF regeneration control module.
2.8 DPF Regeneration
2.9 Anti-theft Matching
2.10 Tire Pressure Reset
2.11 Suspension Level Calibration
2.12 Headlight Matching
2.13 Gearbox Matching
2.14 Sunroof Initialization
This function can learn the EGR (Exhaust Gas Recirculation) valve after it is
cleaned or replaced.
This function can perform tooth learning for the car, to turn off the MIL
It needs to be performed in the following cases:
•
After the engine ECU, crankshaft position sensor, or crankshaft flywheel
is replaced.
•
The DTC “tooth not learned” is present.
2.15 EGR Adaption
2.16 Tooth Learning
This function presents a quick way to check for DTCs, isolate the cause of the
illuminated Malfunction Indicator Lamp (MIL), check monitor status prior to
emissions certication testing, verify repairs, and perform other services that are
emission-related.
Tap “OBD” in the Home Menu after the tablet is properly connected to the vehicle’s
DLC port. The tablet will start an automatic check of the vehicle’s computer to
determine which type of communication protocol it is using, then display the
Monitor Status as follows:
Tap “OK”, the following OBDII function list appears.
3. OBDII/EOBD Diagnostics
Loading ...
Loading ...
Loading ...