Loading ...
Loading ...
Loading ...
08
•
To allow the robot to automatically vacuum and return to
the dock, start the robot from the dock. Do not move the
dock during cleaning.
•
Cleaning cannot start if the battery level is too low. Allow the
robot to charge before starting cleanup.
•
If cleaning is completed in less than 10 minutes, the area
will be cleaned twice.
•
If the battery runs low during the cleaning cycle, the robot
will automatically return to the dock. After charging, the
robot will resume where it left o.
Notes:
Note: After resetting the system, scheduled cleaning, WiFi,
etc. will be restored to factory settings.
If the robot is paused for over 10 minutes, it
will go to sleep, and the power indicator will
ash every few seconds. Press any button to
wake the robot up.
Sleep
Press and hold the button to start spot
cleaning.
Cleaning range: The robot cleans a 1.5 m (4.9 ft)
x 1.5 m (4.9 ft) square area centered on itself.
Spot Cleaning
When the robot is running, press any button
to pause it, press the
button to resume
cleaning, press the
button to send it back
to the dock.
Pause
Note: Placing a paused robot on the dock manually will end
the current cleanup.
Note: After spot cleaning, the robot will automatically return
to the starting point and enter Standby mode.
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND mode is activated, the
robot will not automatically resume cleanup,
the power indicator light will dim, and the
volume of the voice prompts will lower.
DND Mode
•
The robot will not go to sleep when it is charging.
•
The robot will automatically shut down if left in sleep mode for
more than 12 hours.
Notes:
After cleaning, the robot will automatically
return to the dock to charge.
In Pause mode, press the
button to
send the robot back to the dock. The power
indicator will pulse as the robot charges.
Charging
If an error occurs, the power indicator
will flash red and a voice alert will sound.
See “ Errors” for solutions.
Error
If the robot does not respond when a button
is pressed or cannot be turned o, reset
the system. Press the Reset button, and the
robot will reset automatically.
System Reset
Note: If the robot fails to nd the dock, it will automatically
return to its starting location. Place the robot on the dock
manually to recharge.
•
The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
•
Placing a malfunctioning robot on the dock manually will
end the current cleanup.
Notes:
If the robot does not function properly after
a system reset, switch it on. Press and hold
the
button and at the same time press
Reset button until you hear the “Restoring
factory settings” voice prompt. The robot
will then be restored to factory settings.
Restore Factory Settings
App Features
Cleaning Map
•
Multi-Map Management
•
Real-Time Vacuum Route
•
Map Zoning
•
Map Editing
Custom Cleaning Modes
•
Scheduled
•
Selective Room
•
Zone
•
No-Go Zones & Invisible Wall
Zone 1 –
Cleaned
Zone 4 –
Next Zone
Zone 2 –
Cleaned
Zone 3 –
In Progress
Loading ...
Loading ...
Loading ...