Loading ...
Loading ...
Loading ...
12
Unable to power on
•
The battery level is low. Put the robot on the docking station and charge it before use.
•
The battery temperature is too low or too high. Only use the robot within the range of 4-40°C (39-104°F).
Unable to charge
•
Check the power indicator light turns on and both ends of the power cabel are properly connected.
•
If contact is poor, clean the contact areas on the docking station and the robot.
Slow charging
•
When used at high or low temperatures, the robot will automatically reduce its charging speed to extend battery life.
•
The charging contacts may be dirty. Wipe them with a dry cloth.
Unable to dock
•
There are too many obstacles near the docking station. Move it to an open area.
•
The robot is too far from the docking station. Place it closer and retry.
Abnormal behavior
•
Restart the robot.
Noise during cleaning
•
The main brush, side brush, main wheels, or omni-directional wheel may be jammed. Turn o the robot and clean them.
Problem Solution
Unable to connect to WiFi
•
WiFi is disabled. Reset the WiFi and try again.
•
The WiFi signal is poor. Move the robot to an area with good WiFi reception.
•
Abnormal WiFi connection. Reset the WiFi, download the latest mobile app, and retry.
•
The current Roborock robot is not supported. You can nd supported models in the app.
•
Unable to connect to WiFi abruptly. There may be an error with your router settings. Contact Roborock customer
service for additional support.
Scheduled cleaning is not working
•
Keep the robot charged. Scheduled cleaning can only begin when the battery level is above 20%.
Poor cleaning ability or dust falling out
•
The dustbin is full and needs emptying.
•
The lter is blocked and needs cleaning.
•
The main brush is jammed and needs cleaning.
Is power always being drawn when
the robot is on the docking station?
•
The robot will draw power while it is docked to maintain battery performance, but power consumption is minimal.
Does the robot need to be charged for at
least 16 hours the rst three times it is used?
•
No. The robot can be used any time after it has been fully charged.
Cleaning does not resume after recharging
•
Make sure that the robot is not in DND mode. DND mode will prevent cleanup. When cleaning a space requiring a
top-up charge, if the robot was placed manually on the docking station before it returned to the dock automatically,
it will not be able to continue cleanup.
The robot has begun to miss certain spots
•
The wall sensor or cli sensors may be dirty. Wipe them with a soft dry cloth.
The robot cannot return to the docking
station after Spot cleaning or when it has
been moved manually
•
After spot cleaning or a signicant position change, the robot will re-generate the map. If the docking station
is too far away, it may not be able to return to recharge and must be placed on the docking station manually.
Common Issues
Loading ...
Loading ...
Loading ...