Loading ...
Loading ...
Loading ...
7
BEFORE FIRST USE:
1. Remove the water tank and discard the white protective foam from
under the float in the silver base.
2. Clean the filter as described on page 9 before the first use in
humidifier.
ALWAYS use fresh cool water when operating the humidifier. Place
humidifier on a flat surface.
1.
Remove the top cover from the main body, fill water into water tank directly (NOTE:
do not pour water into the mist chamber) or remove water tank from the base and fill
with water and then replace the water tank back into base. Do NOT exceed the MAX
level mark. ONLY FILL WATER INTO REMOVABLE WATER TANK
NOTE: Filtered or distilled water is recommended to avoid white dust if tap water is too
hard.
DO NOT fill water all the way to the rim.
DO NOT use hot water.
DO NOT add any essential oils, medication or salt to water tank or base.
2.
Ensure Mist Chamber Cap is attached to the top of the mist Chamber in the water
tank.
3.
Place top cover on humidifier base, making sure it fits together securely.
Caution: Do not attempt to move the humidifier while full Water. Doing so may cause
leakage of water or too much water will transfer into the base.
4.
Plug the power cord into a wall socket and turn on the unit by using the Control Panel.
NOTE: Full display panel will illuminate when the humidifier is powered ON.
5.
Touch the POWER icon to turn the unit on. Use the digital control panel or the remote
control to adjust the mist output intensity or to use the other features (see page 6).
NOTE: Once the Mode is set, the display panel will revert to the current humidity and
temperature.
SET THE CORRECT HUMIDITY OUTPUT: Adjust the Digital Control Panel so that the mist
rises up to be absorbed by the room air. Do not set the mist output too high, as the
mist cannot be absorbed by the air and may accumulate on the surfaces around the
humidifier.
REMOTE CONTROL
This humidifier includes a remote control to operate your device remotely. Simply pull
out the small plastic tab before use to activate. There are 12 buttons on the remote
and their function is equivalent to the functions of the touch sensors on the control
panel of the device. If you wish to use the remote control, point it at the approximate
level of the control panel with the display. The maximum signal range is 3 m / 10 ft.
6.
When the humidifier runs out of water, the humidifier will beep 3 times and the unit
will stop working. will appear on the display panel. Refill the water tank
and turn on the humidifier. NOTE: You will need to reset the humidifier to the
desired mode and settings.
Loading ...
Loading ...
Loading ...