Loading ...
Loading ...
Loading ...
4. Do a check of the throttle control and throttle trigger
lockout move freely and that the return springs work
properly.
5. Start the product (refer to the instructions under
To
prepare the product for start on page 13
) and apply
full throttle.
6. Release the throttle and make sure that the cutting
attachment stops and remains at a standstill. If the
cutting attachment rotates with the throttle in the idle
position the carburettor idle setting must be checked.
See instructions under the chapter
Maintenance on
page 15
.
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the cutting attachment guard
WARNING:
Do not use a cutting
attachment without an approved and
correctly attached cutting attachment guard.
Refer to,
Accessories on page 21
.
WARNING: Always use the
recommended cutting attachment guard for
the cutting attachment that you use. If an
incorrect or faulty cutting attachment guard
is fitted this can cause serious personal
injury. Refer to,
Technical data on page 20
.
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It
also prevents injuries that occur if you touch the cutting
attachment.
1. Do a visual check for damages, for example cracks.
2. Replace the cutting attachment guard if it is
damaged.
To do a check of the vibration damping system
Note: Use of incorrectly wound cord or an incorrect
cutting attachment increases the level of vibration. See
instructions under
Accessories on page 21
.
The vibration damping system decreases vibration in
the handles to a minimum which makes the operation
easier. The vibration damping system of the product
decreases the transfer of vibration between the engine
unit and the shaft unit of the product.
1. Stop the engine.
2. Do a visual check for deformation and damage for
example, cracks.
331 - 012 - 25.09.2023
7
Loading ...
Loading ...
Loading ...