Loading ...
Loading ...
Loading ...
3. Remove the grease plug.
4. Look into the grease plug hole and turn the drive
shaft. The grease level (A) must be in level with the
top of the gear cogs (B).
A B
5. If the grease level is too low fill the bevel gear with
Husqvarna bevel gear grease. Fill slowly and turn
the drive shaft as you apply the bevel gear grease,
stop at the correct level (B).
CAUTION:
An incorrect quantity of
grease can cause damage to the bevel
gear.
6. Install the grease plug.
Two piece-shaft
Apply grease to the end of the drive shaft after each 30
hours of operation. There is a risk that the drive shaft
ends (splined coupling) on models with two-piece shafts
will seize if they are not lubricated regularly.
Maintenance schedule
The following is a list of the maintenance steps that
must be performed on the product. Most of the items are
described in
Maintenance on page 15
Note: The user must only carry out the maintenance
and service work described in this operator's manual.
More extensive work must be carried out by an
approved service workshop.
Maintenance Daily Weekly Monthly
Clean the external surface. X
Make sure that the throttle trigger lock and the throttle works correctly from a
safety point of view.
X
Do a check of the stop switch to make sure that it works correctly. X
Make sure that the cutting attachment does not rotate at idle speed. X
Clean the air filter. Replace if necessary. X
Examine the cutting attachment guard for damages and cracks. Replace the
guard if it has been exposed to impact or is cracked.
X
Examine the trimmer head for damages and cracks. Replace if damaged. X
Make sure that the screws and nuts are tight. X
Examine the engine, the fuel tank and the fuel lines for leaks. X
Clean the cooling system. X
18 331 - 012 - 25.09.2023
Loading ...
Loading ...
Loading ...